Overview
The Alloy USA 352045 is a Dana 44 TJ master ring and pinion installation kit for 1997-2006 Jeep Wrangler TJ models. It supplies the bearings, pinion seals, shims, crush sleeve, pinion nut and ring gear bolts used in a differential rebuild or ring and pinion install.
It is made for the Jeep Wrangler TJ and has a Direct Fit classification.
Key features
- Master kit for Dana 44 ring and pinion installation
- Bearings, pinion seals, shims and a crush sleeve included
- Ring gear bolts and marking compound included
- TJ application
Matching gears to the case
A master kit covers the bearings and small parts, but the gears must be matched as a set before installation. Ring and pinion sets are cut in pairs, so a mixed set will not mesh correctly. Check the gear ratio against your axle and expected tire size, since the ratio changes how the vehicle accelerates and cruises.
Before installing, inspect the carrier bearing bores, the case for cracks and the ring gear mounting face for burrs. Worn bores or a warped flange can throw off runout and shorten gear life, so address them first. Plan on replacing the ring gear bolts with the new set, since they are often single-use under torque.
- Buy the ring and pinion as a matched set
- Check the ring gear ratio against your tire size
- Inspect carrier bearing bores for wear
- Clean the case before fitting new bearings
- Replace ring gear bolts with the new set
Specifications
| Brand | Alloy USA |
|---|---|
| Part number | 352045 |
| UPC | 70000379281 |
| Axle type | Dana 44 TJ |
| Fitment | Direct Fit |
Vehicle fitment
This kit is made for the 1997-2006 Jeep Wrangler TJ and the Dana 44 axle type.
It is made for the TJ, not the Wrangler JK (2007-2018), LJ (2004-2006) or YJ (1987-1995). Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Ring and pinion setup sets gear mesh and bearing preload, so a specialist with the right tools is the usual choice. The ring gear and pinion gears are not part of this kit and must be matched before assembly.
What’s included
Bearings, pinion seals, shims, a crush sleeve, a pinion nut, ring gear bolts and marking compound are listed.
Not included: ring gear and pinion gears.








