Overview
The Alloy USA 352049 is a Dana 35 rear master ring and pinion installation kit. It supplies the components needed for a differential rebuild or a ring and pinion installation.
No vehicle or year is named. The kit is marked direct fit, but Dana 35 is an axle type, so match it to your rear housing before ordering.
Key features
- Complete kit with bearings and pinion seals
- Pinion shims and crush sleeve included
- Pinion nut, ring gear bolts and marking compound included
- Rear master kit for Dana 35 axles
Setup and break-in
Rear master kits are built around pinion depth and carrier setup, so the gear pattern usually needs professional checking before the axle goes back into service. Marking compound helps show tooth contact during that check, and it is most useful when the gears are rolled slowly under light load.
Once the axle is running, new gears need a break-in period. Early driving should be gentle, with steady loads and no hard launches. Check the fluid level after the first few drives and look for metal in the drain plug, which can point to a setup issue. Keep the housing clean and dry before reassembly.
- Check gear pattern before full use
- Keep the housing clean before assembly
- Use gentle loads during break-in
Specifications
| Brand | Alloy USA |
|---|---|
| Part number | 352049 |
| UPC | 70000379280 |
| Axle type | Dana 35 rear |
| Included | Bearings, pinion seals, pinion shims, crush sleeve, pinion nut, ring gear bolts, marking compound |
Vehicle fitment
The kit is marked direct fit. The Dana 35 rear axle is the only fitment detail, so match it to your rear housing before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A qualified shop should set the gear pattern on these gears, which also need a break-in period before full use.
What’s included
Bearings, pinion seals, pinion shims, crush sleeve, pinion nut, ring gear bolts and marking compound are included. The ring and pinion gears themselves are not part of the kit.








