Overview
The Alloy USA 15100 is a Ford 8.8 rear axle shaft for the passenger side, with 31 splines. It fits the 1986 Ford Bronco and the 1983-1986 Ford F-150.
The shaft is built as an upgrade rather than a like-for-like swap and is up to 35% stronger than stock. It is made from 1541H or 4140 steel. Shaft and gear set engage through splines, so the 31-spline 15100 needs a matching 31-spline differential or carrier. Confirm the rear axle is a Ford 8.8 with 31 splines before ordering. Compare the old shaft’s splines and overall length against this part before installation.
Key features
- Replacement shaft for the Ford 8.8 rear axle
- 31 spline
- Passenger side
- Fits the Ford F-150 and Bronco
- Alloy USA says its shafts are heat treated and induction hardened
- Bearings, seals and studs are not included
- Axle: Ford 8.8 inch rear
- Axle shaft location: Passenger side, rear right
Signs of a worn axle shaft
A worn axle shaft usually shows warning signs before it fails. Clicking or popping during tight turns can point to worn splines or a stressed joint, while vibration under acceleration often traces back to a bent or fatigued shaft. Oil or grease at the inner end suggests the axle seal has let go. Any of these signs is a reason to pull the shaft and inspect it, since a broken shaft can leave a wheel loose under load.
When replacing a Ford 8.8 shaft, look at the spline wear on the differential side gears as well as the shaft, because worn gears will quickly chew up a new shaft. Check the axle bearing and retainer for heat discoloration. Cleaning the splines and applying the correct lubricant before fitting helps the new shaft seat fully and reduces noise over time.
- Clicking on tight turns
- Vibration under acceleration
- Oil or grease at the inner seal
- Spline wear on the differential side gears
Specifications
The 15100 is a replacement axle shaft for the Ford 8.8 inch rear axle, with 31 splines. Every figure in the table below is the manufacturer value for the 15100.
| Brand | Alloy USA |
|---|---|
| Part number | 15100 |
| UPC | 70000329395 |
| Part type | Replacement axle shaft |
| Axle | Ford 8.8 inch rear |
| Axle shaft location | Passenger side, rear right |
| Spline | 31 spline |
| Manufacturer part number | ALY15100 |
| Application stated | 83-83 Ford F-150 and Bronco |
Vehicle fitment
The manufacturer fitment list for the 15100 names: 1986 Ford Bronco; 1983–1986 Ford F-150.
Application: 83-83 Ford F-150 and Bronco.
Before ordering the 15100, compare its spline count, side and overall length with the shaft being replaced.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Before installing the 15100, set aside bearings, seals and studs, since none come with the shaft.
What’s included
One axle shaft.
Not included: Bearings, Seals, Studs.








