Overview
The Alloy USA Dana 44 outer axle shaft, part 10127, is a front left outer stub with 19 splines and a 9.940 inch overall length. It fits the 1971–1983 Jeep Wagoneer (SJ) and the 1984–1991 Jeep Grand Wagoneer (SJ).
The shafts are made from 1541H or 4140 steel, depending on the application. They are heat treated and induction hardened, a process designed to give twice the tensile strength of stock. This shaft is a Dana 44 front outer stub.
Key features
- Front left outer stub shaft
- 19 splines
- 9.940 inch overall length
- 1541H or 4140 steel, heat treated and induction hardened
- Designed to be up to 35% stronger than stock
Wagoneer front axle work
On a Wagoneer front axle, the outer stub shaft carries drive torque to the hub and wheel, and it takes the shocks of off-road driving. Front shafts often wear at the U-joint end and the spline ends, so inspect both before assembling the new shaft. Matching the spline count and length to the stub you removed is the most important step.
Because the shaft is removed with the hub and bearing components, replacing the seals and bearings in the same job saves a second teardown. Clean the bore and splines, check the axle seal for tears, and pack the bearings with fresh grease. Many owners also check the differential fluid while the axle is open.
- Inspect the U-joint for play before installing
- Clean the splines and axle bore
- Replace the hub seal if it shows wear
- Recheck hub and axle nuts after the first drives
Specifications
| Brand | Alloy USA |
|---|---|
| Part number | 10127 |
| UPC | 70000374311 |
| Axle type | Dana 44 |
| Axle location | Front |
| Shaft location | Outer stub |
| Position | Front left outer |
| Spline count | 19 splines |
| Overall length | 9.940 inches |
| Material | 1541H or 4140 steel, depending on application |
| Treatment | Heat treated and induction hardened |
Vehicle fitment
It fits the 1971–1983 Jeep Wagoneer (SJ) and the 1984–1991 Jeep Grand Wagoneer (SJ) across their trims.
Cherokee and Grand Cherokee models are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Measure the stub you are replacing. The 9.940 inch length and 19 spline count are the two figures to match.
What’s included
One front left outer axle shaft.
Not included: U-joint, bearings and seals.









