Overview
The TeraFlex SpeedBump Bumpstop Kit 1958720 is a rear bump stop kit for Jeep Wrangler TJ models from 1997–2006 and Wrangler LJ models from 2004–2006. It adds two composite SpeedBump bump stops with mounting brackets and rubber spring isolators, designed for vehicles with 3 or more inches of lift.
The SpeedBumps use closed-cell, nitrogen-charged microcellular polyurethane to compress progressively, which reduces harsh bottoming. The Delrin acetal resin shaft is self-lubricating and protected by an external shaft seal. Mounting uses rear SpeedBump brackets with integrated coil spring pads.
Key features
- Two rear SpeedBump bumpstops for lifted TJ and LJ Wranglers
- Progressive closed-cell nitrogen-charged microcellular polyurethane body
- Self-lubricating Delrin acetal resin shaft
- External shaft seal against contaminants
- Rear mounting brackets with integrated coil spring pads
- Two rubber spring isolators and adjustment spacers included
Welded mounts and coil springs
Coil-sprung rear axles on TJ and LJ Wranglers rely on the upper spring pad to hold the coil in place, and the bumpstop mounts work with that pad. Replacing the factory pad with integrated brackets changes how load travels into the body, so the bracket welds need a solid base. Before cutting or welding, remove spring tension safely and support the axle. A fabricator can judge whether the frame section is suitable for the added load.
Rubber spring isolators sit between the coil and its seat, and they wear with time. When the spring is out for the install, inspect the isolators and replace any that are cracked or compressed flat. Check that the coil seats squarely on the new pad, and recheck bump stop clearance after the vehicle is back on the ground.
- Inspect rubber isolators for cracks and flat spots
- Confirm the coil sits squarely on the bracket pad
- Check bump stop clearance at full compression
- Protect fresh welds with a coating after cooling
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 1958720 |
| UPC | 843885025184 |
| Position | Rear |
| Lift (description) | 3 or more inches |
| Body | Closed-cell nitrogen-charged microcellular polyurethane |
| Shaft | Delrin acetal resin |
| Mounting | Rear SpeedBump mounting brackets with integrated coil spring pads |
| Installation | Welding required |
| Fitment type | Direct fit |
Vehicle fitment
Listed fitment covers the 1997–2006 Jeep Wrangler (TJ) in 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims, plus the 2004–2006 Jeep Wrangler (LJ) in Unlimited and Unlimited Rubicon trims.
Match your model to the TJ and LJ vehicles covered here; JK and JL Wranglers are a different fit.
Wrangler JK and JL models are not in the listed fitment. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation requires removing the rear factory upper coil spring pad, and welding is required. The kit’s mounting brackets carry their own integrated coil spring pads. Because the work involves welding and a coil spring, have it done by a qualified fabricator and support the vehicle securely before removing any spring components.
What’s included
Two rear SpeedBump bumpstops, adjustment spacers, rear SpeedBump mounting brackets with integrated coil spring pads, and two rubber spring isolators.
Not included: Welding equipment and the skills or labor needed for the welded mounting.









