Overview
The TeraFlex SpeedBump rear bumpstop kit, part number 1958252, is a composite progressive bump stop system for Jeep Wrangler JK models with 2.5-3.5 inches of lift. The kit includes two rear SpeedBump bump stops, two outer bump stop retainer cups and two rear lower bump stop strike pads.
The SpeedBump is built from closed-cell, nitrogen-charged microcellular polyurethane that stays flexible in extreme cold and heat. Its design softens compression impacts that can cause harsh bottoming on rough trails or poorly maintained highways, which can reduce the risk of axle housing bends.
The bump stop has a Delrin acetal resin shaft that is self-lubricating, and an external seal wipes the shaft clean to keep dirt out of the housing. Upkeep is minimal, and no custom adjustment is needed.
Key features
- Progressive composite design that TeraFlex says reduces harsh bottoming
- Closed-cell, nitrogen-charged microcellular polyurethane body
- Delrin acetal resin shaft, self-lubricating
- External shaft seal against dirt and contaminants
- Bolt-on installation with no cutting or welding
- Includes two outer retainer cups and rear lower strike pads
Rear suspension wear signs
Rear bump stops engage when the axle nears full compression, so they see hard impacts on rough terrain and on washboard roads. Over time the polyurethane body can lose its resilience, the shaft can stiffen with grit, and the seal can wear, letting dirt into the housing. Any of these changes shifts how the stop cushions the axle.
Inspect the rear bump stops at regular service intervals, especially after long trail runs or extended highway driving on rough roads. Look at the shaft for grit and check the external seal for tears. If the stop feels uneven or shows visible damage, replace it together with its retainer cup and strike pad.
- Check the external seal for tears or gaps
- Look for grit or wear on the shaft
- Replace the stop with its retainer and strike pad as a set
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 1958252 |
| UPC | 843885025092 |
| Position | Rear |
| Lift range | 2.5-3.5 inches |
| Body material | Closed-cell, nitrogen-charged microcellular polyurethane |
| Shaft | Delrin acetal resin polymer |
| Packaging | Pair |
| Fitment type | Direct fit |
Vehicle fitment
It fits 2007-2015 Jeep Wrangler (JK) models, including the Rubicon, Sahara and Sport trims and the Unlimited versions. It is designed for JK Wranglers with 2.5-3.5 inches of lift.
Vehicles outside that range, such as the 2018 and later JL generation or the 2004-2006 LJ, are not covered by this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This is a bolt-on installation that needs no cutting or welding. Install the SpeedBump with its outer retainer cup in position. Lift height affects bump stop length, so check clearance at full compression after installation.
What’s included
The kit includes two rear SpeedBump bump stops, two outer bump stop retainer cups and two rear lower bump stop strike pads, sold as a pair.









