Overview
The TeraFlex SpeedBump front bumpstop kit, part number 1958251, is a composite progressive bumpstop system for Jeep Wrangler JK models with a 2.5-3 inch lift. It includes two front SpeedBump bumpstops, front adjustment spacers and front lower bumpstop strike pads, and it installs in place of the factory front bumpstop bell.
The SpeedBump is built from closed-cell, nitrogen-charged microcellular polyurethane. The progressive design is intended to soften suspension compressing impacts and harsh bottoming, which can help limit the risk of axle housing bends off-road or on rough highways.
The shaft is made from Delrin acetal resin polymer, which is self-lubricating. An external shaft seal wipes the shaft clean to keep contaminants out of the housing. The SpeedBump is maintenance free and needs no custom adjustment or tuning.
Key features
- Progressive composite design that TeraFlex says reduces suspension compressing impacts
- Closed-cell, nitrogen-charged microcellular polyurethane body
- Delrin acetal resin shaft that is self-lubricating
- External shaft seal that wipes the shaft and keeps contaminants out
- Maintenance free, with no custom adjustment or tuning required
- Bolt-on installation with no welding or cutting
- Includes front adjustment spacers and front lower strike pads
Progressive stops and lift height
A progressive bump stop gets firmer as it compresses, rather than hitting a hard stop all at once. On a lifted Wrangler JK, that matters because the suspension has more travel and the stop engages later. A stop that stiffens gradually can smooth the final part of a compression stroke, which helps the axle housing and mounts when the truck lands hard or drops into ruts.
When fitting a stop like this, the spacers and strike pads decide where engagement happens, so set them before final torque. Check how the stop sits with the shock fully compressed, and confirm the brake lines and CV angles have room. Polyurethane stops can take a set over years of compression, so inspect them during suspension service and replace any that show cracks or flattened sections.
- Check spacer position before final torque
- Confirm brake line clearance at full compression
- Inspect the polyurethane body for flattening or cracks
- Keep the shaft seal clean and free of grit
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 1958251 |
| UPC | 843885025085 |
| Position | Front |
| Lift range | 2.5-3 inch |
| Body material | Closed-cell, nitrogen-charged microcellular polyurethane |
| Shaft | Delrin acetal resin polymer |
| Packaging | Pair |
| Fitment type | Direct fit |
Vehicle fitment
The fitment covers 2007-2015 Jeep Wrangler (JK) models, including the Rubicon, Sahara and Sport trims, with a 2.5-3 inch lift.
Later JL Wranglers, the LJ and the older TJ are not in the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The installation is bolt-on and requires removing the factory front bumpstop bell, with no welding or cutting needed. The front adjustment spacers fine tune the compression length, so check clearance at your lift height after fitting. Lift height and bumpstop length affect suspension clearance, so confirm there is no contact at full compression.
What’s included
The kit includes two front SpeedBump bumpstops, front adjustment spacers and front lower bumpstop strike pads, sold as a pair.









