Overview
The Rugged Ridge cold air intake, part 17750.01, is a bolt-on kit for the 1997–2006 Jeep Wrangler (TJ). It replaces the factory air box with a polished aluminum mandrel bent intake tube, so the engine draws cooler air through a high-flow conical filter. The kit can improve fuel economy by up to 10% and add up to 10HP and 12ft lbs. of torque.
The kit suits owners who want better throttle response and acceleration from a simple, no-drill upgrade. A black powder coated heat shield separates the filter from engine heat, dirt and debris. The dry panel filter never needs oiling, which helps keep the air flow sensor free of excess oil.
Key features
- Polished 6063 aluminum mandrel bent intake tube that replaces the factory air box
- High-flow conical dry panel filter that never needs oiling
- Black powder coated heat shield that separates the filter from engine heat, dirt and debris
- Bolt-on installation with simple hand tools and no drilling
- Stated to improve fuel economy up to 10% and add up to 10HP and 12ft lbs. of torque
- Cold air intake design with an open filter housing
- It is 49 State Legal and is not intended for use in California.
Dry filter care
A dry panel filter is used without oil, so routine service is a matter of inspection and cleaning rather than re-oiling. Remove the filter at intervals and tap out loose dust, then check the pleats for damage. A filter that looks heavily loaded or torn should be replaced, since dirt bypassing the media can reach the throttle body.
On a Wrangler TJ, the open housing makes the filter more exposed to splash and grit than an enclosed setup. Keep it away from standing water and check it after trail runs. Before installation, confirm the heat shield is secured and the tube is seated fully, because a loose joint lets unfiltered air in.
- Tap out loose dust rather than oiling a dry filter
- Inspect the pleats for tears or crushed areas
- Recheck the shield mounts after rough trail use
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 17750.01 |
| UPC | 804314217129 |
| Intake tube material | Polished 6063 aluminum |
| Intake tube construction | Mandrel bent |
| Filter type | High-flow conical dry panel |
| Filter housing type | Open |
| Intake type | Cold air |
| Heat shield finish | Black powder coated |
| Inlet tube | Included |
| Fitment type | Direct fit |
| Fuel economy | Up to 10% |
| Horsepower gain | Up to 10HP |
| Torque gain | Up to 12ft lbs. |
| Legal status | 49 State Legal |
Vehicle fitment
It fits the 1997–2006 Jeep Wrangler (TJ), including the 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims.
It does not cover other Wrangler generations such as the YJ, LJ or JK, or the Cherokee and Grand Cherokee. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation is a bolt-on job with simple hand tools and no drilling. Make sure the engine is cool before starting work on the intake tube and filter.
What’s included
- Polished 6063 aluminum mandrel bent intake tube
- High-flow conical dry panel filter
- Black powder coated heat shield
The inlet tube is included.









