Overview
The K&N Filter 57-1514-1 is a 57 Series performance air intake kit for the Jeep Wrangler TJ and LJ, covering 1997–2006 TJ and 2004–2006 LJ models with the 4.0L six-cylinder engine. Sometimes called a FIPK intake, the kit replaces the restrictive factory air filter and intake housing with a K&N high-flow air filter and an aerodynamically engineered intake tube.
The intake smooths and straightens airflow, reducing restriction so the engine can take in more air than the factory assembly allows. More air can mean more usable power and acceleration across the RPM range. The tube accommodates the factory air temperature sensor and crank case vent hose, and the oversized conical filter can be used for up to 100,000 miles before servicing, depending on driving conditions.
Key features
- Replaces the factory air filter and air intake housing with a complete intake system.
- Aerodynamically engineered intake tube routes air into the throttle body.
- Chrome topped K&N high-flow oil filter that is washable and reusable.
- Heat shield installs into the space the previous air box occupied.
- Tube accommodates the factory air temperature sensor and crank case vent hose.
- Oversized conical filter rated by K&N for up to 100,000 miles, depending on driving conditions.
- It is designed to add power and is 50 State Legal.
- Backed by the K&N Million Mile Limited Warranty.
Wrangler intake upkeep
Wrangler intakes sit in a tight engine bay with plenty of heat and vibration, so the tube, clamps and heat shield can loosen over time. Checking those parts during oil changes or tire rotations catches problems early. The filter and tube are the parts most likely to need attention, while the housing and mounting points usually hold up well with regular inspection.
Trail use adds dust, mud and water to the airflow path. A washable oiled filter should be cleaned when it looks loaded, then re-oiled lightly and reinstalled. Before water crossings, consider how high the filter sits, and avoid submerging the intake. After a rough trip, look for loose clamps and cracked tube sections.
- Check the tube for cracks near the throttle body
- Tighten hose clamps that have worked loose
- Inspect the heat shield after off-road use
Specifications
| Brand | K&N Filter |
|---|---|
| Part number | 57-1514-1 |
| UPC | 24844094865 |
| Series | 57 Series FIPK performance intake |
| Intake type | Cold Air |
| Filter type | Oil |
| Filter housing type | Partial Enclosure |
| Inlet tube | Included |
| Fitment type | Direct Fit |
| Engine | 4.0L six-cylinder |
| Filter | Chrome topped, high-flow, oversized conical, washable and reusable |
| Service interval | Up to 100,000 miles, depending on driving conditions |
| Tube material | High density polyethylene |
| Emissions | Meets CARB and Federal emissions |
| CARB EO number | D-269-34 |
| Warranty | Million Mile Limited Warranty |
Vehicle fitment
It fits the 2004–2006 Jeep Wrangler (LJ), including Unlimited and Unlimited Rubicon versions, and the 1997–2006 Jeep Wrangler (TJ), including Rubicon, SE, Sahara, Sport and X trims.
Wrangler JK and JL models are not in this list, and neither are other generations outside the TJ and LJ years shown. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The heat shield mounts into the space the previous air box occupied, and the tube is shaped to clear the factory air temperature sensor and crank case vent hose. K&N describes installation as usually taking 90 minutes or less, using the existing factory mounting points and commonly available tools.
What’s included
The kit comes with a chrome topped K&N high-flow air filter, a heat shield and the aerodynamically engineered intake tube, which is included.












