Overview
This ring and pinion set has a 4.88 gear ratio and is matched to the Jeep XJ chassis, which covers Jeep Cherokee model years 1984 through 2001. The pinion turns 4.88 times for each full turn of the ring gear, a numerically high ratio that multiplies torque at the wheels.
Confirm the axle size and carrier setup before ordering, and check bearings, shims and hardware separately before installation.
Key features
- 4.88 gear ratio
- Matched to the Jeep XJ chassis
- Notes “w/CRY 8.25” without further detail
Ring and pinion basics
A ring and pinion sets the final drive ratio at the axle, which controls how torque reaches the wheels. A numerically high ratio like 4.88 favors acceleration and low-speed work, while giving up some highway cruise speed.
Because a gear set affects the whole drivetrain, check tire size, the transmission and the transfer case before choosing. Carrier bearings, pinion depth and backlash should be checked and set during installation, and a gear shop is usually the practical route.
Old gears often show wear as whining under load, chipped teeth or metal in the oil, which means the carrier should be inspected at the same time.
- Check the axle size and carrier before buying
- Replace carrier bearings with the new set if worn
- Break in new gears under light loads
- Match the ring gear to the correct pinion
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| UPC | 700007521851 |
| Chassis | Jeep XJ (1984 to 2001) |
| Gear ratio | 4.88 |
Vehicle fitment
It is matched to the Jeep XJ chassis, which covers 1984 through 2001 Cherokee model years. Confirm your year, the axle type and the carrier before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Gear sets need accurate pinion depth and backlash, so a gear shop is the practical installer. Plan on a break-in period.
What’s included
One ring and pinion set rated 4.88.









