Overview
The G2 Axle and Gear 4-XJ3-410 is a front and rear ring and pinion kit for the 1984–2001 Jeep Cherokee (XJ). It includes 4.10 gears for a Dana 30 short front and 4.11 gears for a Dana 35 rear, along with the master installation kits needed for the swap.
Matched master installation kits for the front and rear axles come with the gear sets. G2 states its gears are computer heat treated 8620 steel, manufactured to O.E. specs and backed by a limited lifetime warranty.
Key features
- 4.10 front and 4.11 rear gears
- Dana 30 short front, Dana 35 rear
- Master installation kit for each axle
- Fits 1984 to 2001 XJ Cherokee
- Limited lifetime warranty
Gear swap planning
A ring and pinion swap is one of the more involved drivetrain jobs. Pinion depth, bearing preload and gear backlash all have to be set on each axle before the gears are run. Work done with the wrong setup leads to noise and early gear wear, so the setup should be checked carefully before the vehicle is driven.
Gears are only part of the job. Carriers, bearings, seals and the fluid used all affect how the new set wears. Many installers replace the pinion bearings and seals while the axle is open, and they check the carrier against the gear ratio before assembly. Plan on a fresh gear oil fill after the break-in period, and avoid heavy loads until the teeth have seated.
- Check carrier fit before assembly
- Set pinion depth and backlash on each axle
- Replace seals and bearings while open
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 4-XJ3-410 |
| UPC | 700007521771 |
| Product type | Front and rear ring and pinion sets with master installation kits |
| Gear ratio | 4.10 |
| Front axle gears | Dana 30 Short 4.10 |
| Front carrier | 3.73 and up |
| Rear axle gears | Dana 35 4.11 |
| Rear carrier | 3.54 and up |
| Installation kits | Front and rear matched master installation kits |
| Material | Computer heat treated 8620 steel |
| Manufacturing | Manufactured to O.E. specs, double shot peened, double lapped |
| Warranty | Limited lifetime warranty |
Vehicle fitment
The 4-XJ3-410 fits the 1984 to 2001 XJ Cherokee with a Dana 30 short front axle and a Dana 35 rear axle.
The 4-XJ3-410 does not cover an XJ with a reverse-cut Dana 30 front or any other Jeep model. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The 4-XJ3-410 requires setting pinion depth, preload and backlash on both axles, supported by the master installation kits. Check carriers against the 3.73 and up front and 3.54 and up rear requirements. Expect to use a trained installer.
What’s included
- Front ring and pinion gear set
- Rear ring and pinion gear set
- Front matched master installation kit
- Rear matched master installation kit
Not included: carriers and parts outside the two master installation kits.









