Overview
The 4-XJ3-488 is a front and rear 4.88 ring and pinion kit for the 1984–2001 Jeep Cherokee (XJ), with a Dana 30 short front and a Dana 35 rear. The kit includes the gear sets and matched master installation kits for both axles.
The 4-XJ3-488 uses a short Dana 30 front, while the 4-XJ-488 uses a reverse one. Both ends run the same 4.88 ratio, and the gears are engineered for oversized tires and high performance engines.
Key features
- 4.88 gears front and rear
- Dana 30 short front, Dana 35 rear
- Matched master installation kits
- Fits 1984 to 2001 XJ Cherokee
- Double shot peened, double lapped, 8620 steel
Gear set and carrier planning
A ring and pinion swap is one of the more involved drivetrain jobs, and the gear set is only part of it. Bearings, pinion shims and carrier components all affect the final pattern and backlash, so inspect them while the axles are open. Cleanliness matters too: contamination in the housing can damage new gears quickly, so flush the housings and fill with fresh gear oil.
Gear ratio changes also affect how the vehicle behaves. A 4.88 ratio at both ends pulls strongly at low speed and suits larger tires, but engine output, transmission gearing and speedometer calibration should be checked after the swap. Break the new gears in gently, and re-check the pattern and backlash after the first few drives.
- Check bearings and seals before assembly
- Use fresh gear oil after break-in
- Re-check speedometer calibration
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 4-XJ3-488 |
| UPC | 700007521791 |
| Product type | Front and rear ring and pinion sets with master installation kits |
| Gear ratio | 4.88 |
| Front axle gears | Dana 30 Short 4.88 |
| Front carrier | 3.73 and up |
| Rear axle gears | Dana 35 4.88 |
| Rear carrier | 3.54 and up |
| Installation kits | Front and rear matched master installation kits |
| Material | Computer heat treated 8620 steel |
| Manufacturing | Manufactured to O.E. specs, double shot peened, double lapped |
| Warranty | Limited lifetime warranty |
Vehicle fitment
The 4-XJ3-488 fits the 1984 to 2001 XJ Cherokee with a Dana 30 short front axle and a Dana 35 rear axle.
The 4-XJ3-488 does not cover an XJ with a Dana 30 reverse front, which needs a different kit, or other Jeep models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Swapping both axles to 4.88 means setting the pinion depth, preload and backlash on each, using the master installation kits. The front needs a 3.73 and up carrier and the rear a 3.54 and up carrier, and an experienced installer is recommended.
What’s included
- Front ring and pinion gear set
- Rear ring and pinion gear set
- Front matched master installation kit
- Rear matched master installation kit
Not included: carriers and any parts outside the master installation kits.









