Overview
The G2 Axle and Gear 4-XJ-456 is a front and rear 4.56 ring and pinion kit for the 1984–2001 Jeep Cherokee XJ. It pairs a Dana 30 reverse front axle with a Dana 35 rear axle, and both gear sets come with matched master installation kits for a gear swap.
The XJ Cherokee was built from 1984 to 2001. The kit suits drivers who want gears for oversized tires or a high performance engine. Front gears fit a 3.73 and up carrier, and rear gears fit a 3.54 and up carrier.
Key features
- 4.56 ratio gear sets for both axles
- Front Dana 30 reverse and rear Dana 35
- Matched master installation kits for front and rear
- Fits 1984 to 2001 XJ Cherokee
- Computer heat treated 8620 steel, double shot peened and double lapped
- Limited lifetime warranty
Swapping gears on an XJ
An XJ gear swap changes how the drivetrain works under load. A higher ratio gives more torque at the wheels, which suits bigger tires and steeper climbs, but it also makes the engine work harder at highway speed. Think about how the Jeep is used before committing to a ratio.
The front and rear sets are not interchangeable. Each set goes only with its matching axle, master kit and carrier, so verify the axle code before pulling gears. Backlash and pinion depth need careful measurement, and a rushed setup leads to early wear and noise.
After the swap, check the gear oil and look for leaks at the axle seals. Listen for whine during the first drives and recheck the setup if the noise does not settle.
- Verify the axle before pulling gears
- Measure backlash and pinion depth carefully
- Check gear oil and seals after the swap
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 4-XJ-456 |
| UPC | 700007521721 |
| Product type | Front and rear ring and pinion sets with master installation kits |
| Gear ratio | 4.56 |
| Front axle gears | Dana 30 reverse 4.56 |
| Front carrier | 3.73 and up |
| Rear axle gears | Dana 35 4.56 |
| Rear carrier | 3.54 and up |
| Installation kits | Front and rear matched master installation kits |
| Material | Computer heat treated 8620 steel |
| Manufacturing | Manufactured to O.E. specs, double shot peened, double lapped |
| Warranty | Limited lifetime warranty |
Vehicle fitment
It fits the 1984 to 2001 XJ Cherokee with a Dana 30 reverse front axle and a Dana 35 rear axle. It does not fit the Wrangler or Grand Cherokee, or an XJ with different axles. Confirm fit for your vehicle’s year, model and trim before ordering.
The 4-XJ-456 does not cover the Wrangler or Grand Cherokee, or an XJ with a different front or rear axle. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Setting up the 4-XJ-456 means setting pinion depth, preload and backlash on both axles with the matched master installation kits. Carrier requirements differ front and rear, so check yours first. A trained installer normally handles the swap and the break-in.
What’s included
- Front ring and pinion gear set
- Rear ring and pinion gear set
- Front matched master installation kit
- Rear matched master installation kit
Not included: carriers and any parts beyond the two master installation kits.









