Overview
The G2 Axle and Gear 3-2189-500 is a 5.00 ratio ring and pinion for the rear Ford 10.25 Inch axle. The pinion turns five times for each ring gear revolution, a steep ratio that multiplies torque at the wheels and favors acceleration and low-speed pulling over highway rpm.
The title is the generic “Ring and Pinion Set,” and the specification table carries the part identity. G2 describes its Performance line as made for oversized tires and high-performance engines, with current materials and manufacturing methods. No vehicles or model years are named, so the rear 10.25 inch housing and its carrier are the points to verify before buying.
Key features
- 5.00 gear ratio for the Ford 10.25 Inch rear axle
- Rear axle location
- Ring gear and pinion supplied as one set
- Intended for oversized tires and high-performance engines.
- Built with current materials and manufacturing methods.
Choosing a steep gear ratio
A 5.00 ratio gives the drivetrain a strong start from a stop and helps with heavy loads, but it also raises engine speed at highway speeds. Drivers who mostly run highways may notice more engine noise and fuel use. Think about how you use the vehicle before committing to a ratio this steep.
Gears and carrier parts wear as a system. Inspect the differential bearings, pinion seal and carrier shims when the gears are replaced. Look for pitting or chipped teeth on both gears, since a worn partner tooth can damage a new set quickly. Check the differential fluid for metal debris after the first run.
- Use a gear-rated fluid that suits the new ratio
- Check pinion seal for leaks after the first drive
- Retorque ring gear bolts to specification after break-in
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 3-2189-500 |
| UPC | 631410112108 |
| Axle type | Ford 10.25 Inches |
| Axle location | Rear |
| Gear ratio | 5.00 |
| Axle manufacturer | Ford |
Vehicle fitment
This 5.00 set is matched to the rear Ford 10.25 Inch axle. Confirm the housing, ring gear size and carrier on your vehicle before ordering. A different axle size needs a set made for that housing.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A 5.00 set needs measured tooth contact and carrier preload, so most installers hand the job to a gear shop. Break in the new gears before towing.
What’s included
One 5.00 ring and pinion set for the rear Ford 10.25 Inch axle, part number 3-2189-500.
Not included: Carrier bearings and shims are not part of the 5.00 set.









