Overview
The G2 Axle and Gear 2-2034-456 is a 4.56 ratio ring and pinion for the Dana 60 axle. The pinion makes 4.56 turns for each full turn of the ring gear, a numerically high ratio that multiplies torque at the wheels, which is the reason G2 pairs this kind of gear with oversized tires.
The set is made for Dana 60 axles in front and rear positions and is built for oversized tires and high-performance engines. Verify the housing, its location and the carrier on your vehicle before purchase.
Key features
- 4.56 gear ratio for the Dana 60 axle
- Fits front and rear axle locations
- Ring gear and pinion supplied as a matched set
- Designed for oversized tires and high-performance engines.
- Built with current materials and manufacturing methods.
Dana 60 setup and wear
The Dana 60 is a heavy axle, and a 4.56 set changes how it works under load. Torque at the wheels increases, which helps with large tires and steep grades, while engine speed at cruise rises. Plan the gearing around how the vehicle is used most of the time, not only for occasional heavy pulls.
Measure the ring gear and check the housing before buying, because front and rear Dana 60 setups differ. Carrier preload and pinion depth need to be checked after installation, and the new teeth need a gradual break-in run before towing heavy loads. Chatter, whine or heat that appears after the break-in period is worth looking at promptly, since early setup problems tend to grow.
Replace worn carrier bearings, pinion seals and axle seals while the gears are out. Fresh gear oil after the break-in run helps the new set wear evenly, and the fluid should be checked on a regular schedule, especially after towing or off-road use.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2034-456 |
| UPC | 631410094169 |
| Axle type | Dana 60 |
| Axle location | Front or rear |
| Gear ratio | 4.56 |
| Axle manufacturer | Dana |
Vehicle fitment
Confirm the housing and location on your vehicle before ordering. This 4.56 set is made for the Dana 60 in front or rear positions.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A 4.56 set has to be set up with measured tooth contact and carrier preload, and a gear shop is the practical route. Break the gears in before towing heavy loads.
What’s included
One 4.56 ring and pinion set for the Dana 60 axle, part number 2-2034-456.
Not included: Carrier bearings, shims and hardware are not included with the 4.56 Dana 60 set.
















