Overview
The G2 Axle and Gear 2-2088-373 is a 3.73 ratio ring and pinion for the Ford 8.8 Inch IFS axle. IFS stands for independent front suspension, so the title points to a front-axle application. The pinion turns 3.73 times for each ring gear revolution, a middle-range ratio that balances low-speed pulling with highway rpm.
The set may be used front or rear, so confirm the axle position before ordering. Performance Ring and Pinion sets are built for oversized tires and high-performance engines, using current materials and manufacturing. Confirm the axle position and housing before ordering.
Key features
- 3.73 gear ratio for the Ford 8.8 Inch IFS axle
- Independent front suspension (IFS) axle design.
- Ring gear and pinion supplied as one set
- Designed for oversized tires and high-performance engines.
- Built with modern materials and methods.
Front axle considerations
IFS gears run in a front housing that also carries steering and drive joints, so access is tighter than on a rear axle. A middle-range 3.73 ratio balances low-speed pulling with moderate engine speed at highway speed, which suits everyday driving with mixed tires. Front gear work is usually planned around the axle’s position and its half shafts.
Because the front housing is opened for the gear swap, other parts are often renewed too. Front axle seals, CV boots and differential bearings are common additions, and the front fluid should be changed with fresh oil. Check the front U-joints and driveline before reassembly so the job does not repeat soon.
- Confirm the axle is front-mounted
- Replace front axle seals during the job
- Inspect CV boots before reassembly
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2088-373 |
| UPC | 631410105384 |
| Axle type | Ford 8.8 Inches, IFS |
| Axle location | Front or rear (per attributes); IFS (per title) |
| Gear ratio | 3.73 |
| Axle manufacturer | Ford |
Vehicle fitment
Confirm that your axle is an 8.8 inch IFS unit and that it sits at the front before ordering. A gear shop can check the axle position if the housing is unclear.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
An IFS gear set involves pinion depth and carrier preload inside a front housing, which is harder to reach than a rear. A gear shop with setup tools is the practical installer, followed by a break-in run.
What’s included
One 3.73 ring and pinion set for the Ford 8.8 Inch IFS axle, part number 2-2088-373.
Not included: Carrier bearings, shims and hardware are not part of the 3.73 IFS set. Check the package contents against your installation before starting.
















