Overview
The G2 Dana 44 JK rear 5.38 ratio ring and pinion, part number 2-2052-538, is a gear set for the rear Dana 44 axle in the 2007–2018 Jeep Wrangler (JK).
G2 Axle and Gear builds these sets to original equipment specifications, using computer heat-treated 8620 steel. The gears are double shot peened and double lapped, and the set carries a 10-year warranty.
Key features
- 5.38 gear ratio for a rear Dana 44 axle
- Computer heat-treated 8620 steel
- Double shot peened and double lapped
- Manufactured to original equipment specifications
- 10-year warranty
Break-in and setup notes
A new ring and pinion set benefits from a careful first stretch of driving. Keep speeds moderate, avoid heavy towing, and let the gears settle before asking them for hard acceleration or loaded work. Early attention to noise and temperature shows whether the setup is right. Watch for whining or heat.
Setup is the part that determines how long the gears last. Pinion depth and backlash should be checked with a dial indicator and the tooth contact read with marking compound. Bearings, the crush sleeve and the pinion nut should be fresh so preload holds. Recheck the fasteners and fluid level after the break-in period is complete.
- Replace worn pinion bearings with the gear set
- Torque fasteners evenly and recheck them
- Use fresh gear oil before the first drive
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2052-538 |
| UPC | 631410094626 |
| Axle location | Rear |
| Axle type | Dana 44 JK |
| Gear ratio | 5.38 |
| Carrier | For use with a 3.73 and down carrier |
| Material | 8620 steel, computer heat-treated |
| Warranty | 10 years |
Vehicle fitment
Based on the product name, this set is for the rear Dana 44 axle in the 2007–2018 Jeep Wrangler (JK).
It is not for the 2018–2022 Wrangler (JL) or the older TJ and LJ. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check your carrier before installing this set, since it is meant for a 3.73 and down carrier. Pinion depth and backlash are set during installation, and the new gears need a break-in period.
What’s included
One ring and pinion gear set.
Not included: Pinion bearings are not included with this set.














