Overview
The G2 Axle and Gear 1-2095-373 is a 3.73 ratio O.E.M. series ring and pinion for the GM 8.25 inch IFS front axle. It is made for the front location and matches the 8.25 inch IFS axle type.
The O.E.M. series in this 3.73 set is designed to run cooler and quieter than aftermarket gears. It is made under contract with original equipment manufacturers, and the 3.73 ratio gives more torque multiplication at the wheels than a 3.42 set.
Key features
- O.E.M. series 3.73 ring and pinion
- GM 8.25 inch IFS front axle type
- Front axle location
- Made under contract with original equipment manufacturers.
- Runs cooler and quieter than aftermarket gears.
Running the 3.73 ratio
A 3.73 ratio turns the driveshaft more times per wheel revolution than a numerically lower set, which means more torque at the tire contact patch. That helps with heavier tires and steep grades, but it also raises engine speed at highway cruising, so gear choice should match how the truck is used most of the time.
Ring and pinion gears are usually replaced as a set with new pinion bearings, crush sleeve or shims, and pinion seal. Reusing worn bearings with fresh gears leads to noise and early failure. Inspect the carrier bearings and the differential case for wear before the new set goes in.
- Check the carrier for pitting or cracked teeth before installation
- Replace pinion bearings and seals with the new set
- Refill with a gear oil suited to the axle
- Re-check backlash after the first few drives
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 1-2095-373 |
| UPC | 631410093094 |
| Gear ratio | 3.73 |
| Axle location | Front |
| Axle type | GM 8.25 inch IFS |
| Popular axle manufacturer | GM |
| Series | O.E.M. |
Vehicle fitment
No vehicle model or year is tied to this 3.73 set. It is built for the GM 8.25 inch IFS axle at a 3.73 ratio, so confirm the axle type before ordering.
Only the GM 8.25 inch IFS is named for this 3.73 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A driveline shop should set pinion depth, backlash and bearing preload on the 8.25 inch IFS 3.73 gears before the front axle is put into a break-in period.
What’s included
A matched O.E.M. series ring and pinion for the 8.25 inch IFS front axle.
















