Overview
This is a 4.88 ratio thick ring and pinion for the GM 14 bolt 10.5 inch rear axle. It works with 4.10 and down carriers, so the carrier ratio should be 4.10 or numerically lower.
G2 describes its performance ring and pinion sets as engineered for oversized tires and high performance engines. This thick version uses computer heat treated 8620 steel with double shot peened and double lapped surfaces.
Key features
- Thick version 4.88 ring and pinion
- GM 14 bolt 10.5 inch rear axle
- For use with 4.10 and down carriers
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Before you install
A thick ring and pinion has a heavier gear body than a standard set, which suits high torque use on the GM 14 bolt 10.5 inch axle. The trade-off is that the gear set needs the right carrier to match. Confirm the carrier ratio and the axle housing before starting the job.
Gear work on a 14 bolt axle is an opportunity to inspect the carrier and axle bearings. Worn carrier bearings or chipped teeth on the old gears are signs the whole assembly needs attention. Pinion depth, backlash, and bearing preload should be set on a bench before the axle goes back in, and a break-in period helps the new teeth seat properly.
- Inspect the old carrier bearings
- Check the axle housing for cracks or leaks
- Set backlash by contact pattern
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2023-488X |
| UPC | 631410093612 |
| Gear ratio | 4.88 |
| Axle location | Rear |
| Axle type | GM 14 bolt 10.5 inch |
| Popular axle manufacturer | GM |
| Carrier requirement | 4.10 and down |
| Version | Thick |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
This 4.88 set fits the GM 14 bolt 10.5 inch at a 4.88 ratio. Confirm the axle and carrier before ordering.
Other GM axle sizes and the standard, non-thick 10.5 inch gears are separate parts. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The 4.88 thick gears need a driveline shop to set pinion depth, backlash and bearing preload, followed by a break-in period on the 10.5 inch carrier.
What’s included
A matched thick ring and pinion for the GM 14 bolt 10.5 inch rear axle.














