Overview
The G2 Axle and Gear 1-2021-308 is a 3.08 ratio O.E.M. series ring and pinion for GM 10 bolt 8.5 inch and 8.6 inch axles. It is made for both front and rear locations.
The O.E.M. series in this 3.08 set runs cooler and quieter than aftermarket gears. The gears are made under contract with original equipment manufacturers, and a 3.08 ratio gives less torque multiplication at the wheels than higher numerical ratios.
Key features
- O.E.M. series 3.08 ring and pinion
- GM 10 bolt 8.5 inch and 8.6 inch axle types
- Rear and front locations listed
- Made under contract with original equipment manufacturers.
- Runs cooler and quieter than aftermarket gears.
Front and rear gear choices
A 3.08 ratio on the 8.5 inch and 8.6 inch 10 bolt axles is the lower-torque option. It keeps engine speed low at highway speed and tends to be quieter and easier on fuel. Acceleration from a stop and climbing will feel softer, so it suits lighter loads and daily driving.
Front and rear positions carry different loads, so the set should match the axle it goes into. Pinion depth, backlash and bearing preload need to be checked after installation. Replacing the carrier bearings with the set helps the new gears hold alignment over time.
- Confirm the axle size before buying
- Replace carrier and pinion bearings during the swap
- Check backlash and tooth contact pattern
- Keep gear oil clean and at the right level
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 1-2021-308 |
| UPC | 631410092790 |
| Gear ratio | 3.08 |
| Axle location | Front and rear |
| Axle type | GM 10 bolt 8.5 inch and 8.6 inch |
| Popular axle manufacturer | GM |
| Series | O.E.M. |
Vehicle fitment
This 3.08 set is made for GM 10 bolt 8.5 inch and 8.6 inch axle types. Confirm the housing size before ordering.
Other GM axle sizes fall outside the 8.5 inch and 8.6 inch types this set is made for, so check your vehicle’s year, model and trim.
Installation notes
Pinion depth, backlash and bearing preload on the 3.08 gears should be set by a driveline shop before the axle is run in.
What’s included
A matched O.E.M. series ring and pinion for the 3.08 ratio.















