Overview
The ReadyLift 66-3086 is a 2.25-inch front leveling kit that includes replacement upper control arms, written for 2017–2018 GM 1500 trucks. It pairs CNC-machined billet aluminum leveling components with DOM-tube steel upper control arms that replace the factory stamped steel arms.
ReadyLift explains that GM changed the upper control arms on the 1500 pickups to stamped steel, which gives the factory ball joint little support when the truck is lifted or leveled. ReadyLift says GM does not allow lift or leveling kits on these trucks, so this kit is designed to replace the arms as well as level the front. The listed fitment is wider than the 2017–2018 pickups and covers 2016–2019 Escalade, Silverado, Suburban, Tahoe, Sierra, Yukon and Yukon XL models.
Key features
- 2.25 inch front leveling through billet aluminum components
- DOM-tube steel upper control arms, a direct replacement for the factory stamped steel arms
- Heavy-duty ball joints in the new upper control arms
- Anti-resistance bushing that ReadyLift describes as maintenance free and self-lubricating
- Designed to keep the factory ride and geometry rather than add pressure to stock parts
Replacement arm design
Upper control arms carry the ball joint and set the upper end of the front geometry, so arm design affects how the front handles after a lift. Replacement arms are often made from heavier tube or forged parts, and their bushings and ball joints determine how the front holds its alignment over time. Comparing arm construction, bushing type and ball joint design helps set expectations for wear.
Inspect new arms and their bushings at each service interval for cracks, torn boots, play at the ball joint and worn bushing rubber. Replacing both sides together keeps the geometry balanced. Check that bolts are tightened properly and recheck them after the first drives, since fresh bushings settle during early use.
- Look for play at the ball joint
- Check bushings for cracks or splits
- Replace arms in pairs
- Recheck torque after initial driving
Specifications
| Brand | ReadyLift |
|---|---|
| Part number | RDY66-3086 |
| Front lift height | 2.25 inch |
| Lift method | Strut spacers with steel upper control arms |
| Leveling material | CNC-machined billet aluminum |
| Upper control arms | DOM-tube steel |
| Rear lift | None, front lift only |
| Finish | Unfinished |
| Bump stops | None |
Vehicle fitment
It fits the 2016–2019 Cadillac Escalade and Escalade ESV, the 2016–2019 Chevrolet Silverado 1500, Suburban and Tahoe, and the 2016–2019 GMC Sierra 1500, Yukon and Yukon XL.
The kit is built for the 2017–2018 GM 1500 trucks, which have the stamped steel arms. Trucks from 2015 and earlier, and models from 2020 onward, are not covered. Check the year, model and trim against your vehicle before buying.
Installation notes
Install the kit without the lower horseshoe spacer to keep the correct height and suspension geometry. Measure from the center of the wheel hub to the bottom edge of the fender at the 12 o’clock position with a plumb bob. A reading greater than 22 inch means the truck already has some factory or aftermarket front lift, and the kit must be modified to account for it.
What’s included
The leveling components and the DOM-tube steel upper control arms, which ReadyLift describes with heavy-duty ball joints and an anti-resistance bushing.










