Overview
The ReadyLift 66-1030 is a 2-inch front leveling kit for the 2009–2010 and 2011–2018 Ram 1500. It uses a pair of CNC machined 6061-T6 billet aluminum strut extensions that mount on top of the strut, with front lift only and no track bar drop.
The 2-inch height levels a 2009–2010 Ram 1500 without leaving the truck nose high. The modest lift keeps the suspension and drivetrain within a moderate range of travel, which can help limit wear on the CV joints. On 2011–2018 4WD trucks, about half an inch of rake remains after leveling. The kit allows tires up to 35 inches on 2006–2017 trucks. The strut extensions are unfinished and come without bump stops. The billet design leaves the spring in place while the truck is leveled.
Key features
- 2-inch front lift from billet aluminum strut extensions
- Mounts on top of the strut without compressing the spring
- Modest lift height intended to help protect the CV joints.
- Tires up to 35 inches on 2006–2017 trucks.
Matching lift to tire fit
Front leveling changes the height of the front axle only, so the gap between the tire and the fender changes at the front. Before choosing a tire, check the wheel offset and the fender room, since a wider tire can rub at the inner liner when the wheels turn. Front-only kits also leave the rear at its original height, which affects the load carrying angle of the whole truck.
Billet strut extensions are solid parts, so they do not wear like rubber, but the mounts and joints around them still need attention. Check the upper mount, the bump stop and the driveline angles after the first few trips. Address any change in steering feel or noise over bumps early.
- Confirm front-to-rear height once the truck is loaded
- Pair the lift with a tire that clears the fender at full lock
- Inspect CV boots during routine service
- Check the upper strut mount for looseness
Specifications
| Brand | ReadyLift |
|---|---|
| Part number | RDY66-1030 |
| Type | Front leveling kit with strut extensions |
| Front lift | 2 inches |
| Rear lift | Front lift only |
| Material | 6061-T6 billet aluminum, CNC machined |
| Finish | Unfinished |
| Bump stops | None |
| Track bar drop | Not included |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2009–2010 Dodge Ram 1500 in the Laramie, SLT, ST, Sport, TRX and TRX4 trims, and the 2011–2018 Ram 1500 in the Big Horn, Express, Laramie, Laramie Longhorn, Outdoorsman, SLT, ST, Sport, Tradesman and Tradesman HD trims.
The list does not cover the 2008 Ram 1500 or the 2019 and later trucks. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The extensions change the front height, so have the alignment checked after installation and confirm the level once the truck is loaded as usual.
What’s included
A pair of billet aluminum strut extensions and the hardware for the front position.









