Overview
The G2 Toyota 10.5 in Master Ring and Pinion Install Kit, catalog number 35-2064, is a ring and pinion installation kit from G2 Axle and Gear. The title places it with Toyota axles and gives a 10.5 in ring gear size.
Ring and pinion kits are used when a ring gear and pinion set is replaced in an axle. Included parts and setup specifications are unknown, so check them before starting.
Setting up the ring and pinion
Setting up a ring and pinion means matching the pinion depth, bearing preload, and gear mesh so the teeth carry load correctly. Small changes in these settings can cause noise, heat, or early wear, which is why the work is usually done by a technician with specialty tools. Careful measurement at the start saves time later.
Inspect the carrier bearings, pinion bearings, and housing before installing a new set. Check the axle for worn bearing surfaces, and replace any crush sleeve or spacer that is damaged. After assembly, confirm the gear contact pattern and backlash before the axle goes back into service, since a poor pattern is a common cause of noise.
- Check the gear pattern before final assembly
- Replace crush sleeves or spacers as needed
- Use fresh gear oil after the break-in
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Catalog number | 35-2064 (from title) |
| Ring gear size | 10.5 in |
| Application | Toyota axle (per title) |
Installation notes
Setting up a ring and pinion means adjusting bearing preload and gear mesh, which normally requires a qualified technician with specialty tools. Check the setup procedure from the manufacturer before starting.
Vehicle fitment
Confirm the Toyota axle, year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the pinion, ring gear, shims and bearings against your installation before starting.






