Overview
It is a master ring and pinion install kit for a rear Dana 44 on a non-Rubicon Jeep JK, set up for an ARB air locker.
Check the package contents against your installation before starting.
Key features
- Rear Dana 44 install kit
- Non-Rubicon JK application
- Set up for an ARB air locker
Before a gear install
A ring and pinion swap changes the gear mesh at the carrier, so the install is more than bolting parts in. Pinion depth sets where the gear meets the ring, and bearing preload sets how tight the carrier runs. Both need measuring with the right tools, and tooth contact should be checked before the cover goes on for good.
With a locker installed, the carrier and locker parts also need to clear each other, and the locker setup can change how the axle is shimmed. Replace worn carrier bearings and seals during the same job, since old bearings can change preload and gear mesh. Keep the old parts labeled until the new set is checked.
- Measure pinion depth before final assembly
- Set bearing preload to the gear set’s requirements
- Check tooth contact with marking compound
- Check locker clearance against the carrier
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2053ARB |
| UPC | 631410130317 |
| Axle location | Rear |
| Axle type | Dana 44 |
| Locker | Set up for an ARB air locker. |
Vehicle fitment
It is set up for a non-Rubicon JK rear with an ARB air locker. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A ring and pinion install needs gear setup, preload and tooth contact checks, so have it done by a shop that works with gear sets.
What’s included
Install kit for the rear Dana 44 ring and pinion set-up. Check the package contents against your installation before starting.





