Overview
The G2 Toyota 8 in 29 spline master ring and pinion install kit with factory locker, catalog number 35-2058L, is a ring and pinion kit from G2 Axle and Gear. It has an 8 in ring gear, 29 splines and a factory locker setup.
Spline count and locker configuration matter when matching a ring and pinion, so compare them with your axle before ordering. This kit has an 8 in ring gear, 29 splines and a factory locker setup.
Matching gears and locker type
Gear sets are matched as pairs, so the ring gear, pinion and spline count need to agree before anything is installed. A factory locker changes how the axle shares torque between the wheels, which affects how the carrier is built and set up. Mixing a locker-equipped carrier with an open-carrier gear set can cause problems that show up as noise or early tooth wear.
Before buying, check the pinion spline count and ring gear size on your existing axle against the kit, and look at the bearing and seal sizes that go with the gears. When the set is installed, it needs proper preload and tooth contact checks, and a shop with alignment equipment is the usual choice for that work. Expect to replace the pinion nut, crush sleeve and shims at the same time, since they are commonly reused incorrectly.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Catalog number | 35-2058L (from title) |
| UPC | 631410128857 |
| Ring gear size | 8 in |
| Spline count | 29 |
| Locker type | Factory locker |
Installation notes
A ring and pinion set-up relies on exact bearing preload and tooth contact, so a shop with alignment equipment should handle the install and break-in. Do not run the axle until the setup is verified.
Vehicle fitment
This is a Toyota 8 in ring and pinion set. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the individual gears, bearings and shims against your installation before starting.







