Overview
The Pro Comp 929511B is a PRO-X twin tube rear shock absorber for the 2000–2015 Toyota Tundra in several trims, including the 1794 Edition, Base, Limited, Platinum, SR, SR5 and TRD Pro. It has a 29.8-inch extended length, a 17.1-inch collapsed length and an 11.5-inch travel length.
The PRO-X line is a general-purpose twin tube design for trucks used mainly on pavement, with occasional off-road use. This shock has 10-stage velocity sensitive valving, a 1-3/8-inch nylon banded piston and a 5/8-inch chrome hardened shaft, along with a Teflon rebound stop that Pro Comp says supports a comfortable highway ride.
The upper mount is a stem and the lower mount is a loop. The shock body is 2.0 inches in diameter and finished in black powder coat, with a nitrogen stabilized gas charge. The optional shock boot is sold apart from the shock.
Key features
- Twin tube design for general-purpose use
- 10-stage velocity sensitive valving
- 1-3/8-inch nylon banded piston
- 5/8-inch chrome hardened shaft
- Stem upper mount
- Black powder-coated finish
Rear shock service on a Tundra
The rear shocks on a Tundra carry the weight of the bed and any cargo, so they wear faster on trucks that tow or haul regularly. Rear twin tube shocks control rebound after bumps and keep the rear tires on the road when the truck is loaded. Signs of wear include bouncing over dips, a rear end that squats too far under load, and fluid that has seeped onto the body.
Replacement shocks should be matched to the truck’s height, which can change after a lift, a new set of springs, or a heavier bed setup. Check the upper stem mount and lower loop mount for rust and bushing wear before fitting a new unit. The boot is sold separately on this shock, so inspect any existing boot for tears and dust-filled folds before reusing it.
- Note bounce after speed bumps
- Check rear squat under a loaded bed
- Look for seepage on the shock body
- Replace rear shocks in pairs
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 929511B |
| Shock series | PRO-X |
| Shock type | Twin tube, gas charged (nitrogen stabilized) |
| Position | Rear |
| Extended length | 29.8 in |
| Collapsed length | 17.1 in |
| Travel length | 11.5 in |
| Body diameter | 2.0 in |
| Piston | 1-3/8 in nylon banded |
| Shaft | 5/8 in chrome hardened |
| Upper mount | Stem |
| Lower mount | Loop |
| Finish | Black powder coat |
| Boot | Optional, not included |
Vehicle fitment
It fits the 2000–2015 Toyota Tundra in the 1794 Edition, Base, Limited, Platinum, SR, SR5 and TRD Pro trims.
Tundra model years after 2015 are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The stem upper mount and loop lower mount should be matched to the existing Tundra brackets before installation. Compare the 29.8-inch extended and 17.1-inch collapsed lengths with the installed suspension, and check clearance at full compression.
What’s included
One rear twin tube shock with a stem upper mount and loop lower mount. The optional boot is not part of the shock.
Not included: the optional boot.









