Overview
The Pro Comp PR2089 is a PRO-M monotube rear shock absorber for the Jeep Wrangler TJ (1997–2006) and the Wrangler LJ Unlimited (2004–2006). It is designed for Wranglers with a 3-inch lift and has a 22.9-inch extended length and a 14.8-inch collapsed length.
Pro Comp builds the PRO-M with an internal floating piston that keeps oil and nitrogen gas apart, which the company says limits cavitation under hard use. Multi-stage valving is set for this application, and the 2.0-inch body carries extra oil for heat control on off-road trips.
The shock is a rear unit with loop eyes at both ends, finished in silver powder coat with a 14mm chrome hardened shaft. A polyurethane shock boot is included, and the wiper seal has been redesigned to resist leaks. Pro Comp rates the shock for models with a 3-inch lift, so the extended and collapsed lengths are the figures to check against your suspension before fitting.
Key features
- Monotube body with an internal floating piston
- Multi-stage disc pack valving
- 2.0-inch shock body with increased oil capacity
- Redesigned wiper seal
- 14mm chrome hardened shaft
- Silver powder-coated finish
Confirming a 3 inch lift
Shock length matters most when the lift is set correctly. A shock that is too long or too short for the installed height can bind at full droop or run out of travel on a trail. Measure the rear height before fitting, then compare that measurement with the extended and collapsed lengths before deciding. Ride quality and axle control both depend on that match.
Monotube shocks handle heat better than some twin tube designs because the oil has more room to move. Long descents and repeated articulation still generate heat, so inspect the boot and body for oil film after trips. Clean the body and mounts before reinstalling, and keep the boot seated. Replace the bushings if they show cracking.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | PR2089 |
| Shock series | PRO-M |
| Shock type | Monotube, nitrogen gas charged |
| Position | Rear |
| Extended length | 22.9 in |
| Collapsed length | 14.8 in |
| Shock body diameter | 2.0 in |
| Shaft | 14mm chrome hardened |
| Upper mount | Loop |
| Lower mount | Loop |
| Finish | Silver powder coat |
| Lift height | With a 3-inch lift |
| Boot | Polyurethane, included |
Vehicle fitment
It fits the 2004 to 2006 Jeep Wrangler LJ Unlimited and Unlimited Rubicon, and the 1997 to 2006 Jeep Wrangler TJ in the 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims.
The LJ entry covers the Unlimited models only, and the 2007 and later JK Wrangler is not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The shock is sized for a 3-inch lift. Check the 22.9-inch extended and 14.8-inch collapsed lengths against your installed lift, and make sure the shock clears the frame and the axle at full droop and full compression.
What’s included
One rear monotube shock with a polyurethane boot. Check the mounting hardware against your installation before starting.









