Overview
The Pro Comp Suspension PR2086 is a PRO-M front monotube shock for older Jeep CJ models with 3 to 4 inches of lift. It fits the 1959 to 1983 Jeep CJ5, the 1976 to 1986 Jeep CJ7 and the 1960 to 1983 Toyota Land Cruiser.
The shock is nitrogen gas charged and uses a floating piston to separate oil from gas. It has an extended length of 22.4 inches and a collapsed length of 14.5 inches.
Key features
- Front monotube design for 3 to 4 inches of lift
- Extended length 22.4 inches, collapsed length 14.5 inches
- 2 inch diameter body
- Nitrogen gas charged with floating piston
- Multi-stage disc pack valving, vehicle specific
- Polyurethane shock boot included
Older frames and worn parts
Older CJ models often carry worn bushings, bent brackets and fatigued frame mounts from years of use. Before fitting any new front shock, look for cracks around the mounts and check that the steering box and track bar are secure. A shock that binds on a tired frame can wear out quickly even when the shock itself is new.
Lifting an older Jeep also changes the steering geometry, so the front end should be checked for alignment and play in the tie rod ends. Keep an eye on the brake lines and the axle vent when the front is raised. A careful inspection of the old parts helps the new shock last and keeps the steering predictable on the trail.
- Inspect frame mounts for cracks
- Check tie rod ends for play
- Look at brake lines near the axle
- Verify the steering box is secure
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2086 |
| Shock series | PRO-M |
| Position | Front |
| Body diameter | 2 in |
| Extended length | 22.4 in |
| Collapsed length | 14.5 in |
| Upper and lower mount | Loop |
| Lift | 3 to 4 in |
| Finish | Silver powder coat |
Vehicle fitment
It fits the 1959 to 1983 Jeep CJ5 in Base, Golden Eagle, Laredo, Limited and Renegade trims, the 1976 to 1986 Jeep CJ7 including Golden Hawk, and the 1960 to 1983 Toyota Land Cruiser Base.
It does not fit the Wrangler, Cherokee or other Toyota models. Confirm fit for your year, model and trim before ordering.
Installation notes
Compare the 22.4 inch extended and 14.5 inch collapsed lengths with the shock being removed, because the 3 to 4 inch lift range changes the ride height on an older CJ. Loop mounts at both ends should be checked against the factory brackets, which on older Jeeps may have worn. Look for clearance at full compression, and inspect the polyurethane boot after the first drive.
The 3 to 4 inch lift on a CJ affects the steering and the front suspension geometry, so check the alignment after installation. Confirm the loop mounts are secure, and that the shock body clears the front spring and the axle at full compression.
Confirm the shock is clear of the steering linkage and the brake lines at full lock, and check that the shock body does not contact the frame at full droop.
What’s included
One PRO-M front monotube shock with polyurethane boot under part number EXPPR2086.









