Overview
The Pro Comp Suspension PR2039 is a PRO-M rear monotube shock for 2011 to 2013 Chevrolet Silverado and GMC Sierra heavy duty pickups, including the 2500 HD and 3500 HD. It is designed for 0 to 2 inches of lift and is sold individually.
The shock has a nitrogen gas charged body and a floating piston. The 2 inch body holds more oil, which helps it shed heat on off-road trips.
Key features
- Rear monotube design for 0 to 2 inches of lift
- Extended length 26.7 inches, collapsed length 17.7 inches
- 2 inch diameter body
- Nitrogen gas charged with floating piston
- Multi-stage disc pack valving, vehicle specific
Heavy duty rear loads
Heavy duty Silverado and Sierra pickups often carry heavy loads, towing or work gear in the bed, and the rear shocks absorb that weight every mile. Over time the damping oil breaks down and the shock loses control, so the truck can feel bouncy on the highway. Choosing a shock built for the truck’s class helps the rear keep a steady ride.
Loop mounts take most of the stress at the rear, so check the bushings and eyes for cracks or wear at the same time. Pay attention to the mounting hardware before installing and tighten it to factory torque. A quick look at the boot, shaft and body during oil changes catches most problems early.
- Check loop mounts for cracks
- Look for oil seepage on the body
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2039 |
| Shock series | PRO-M |
| Position | Rear |
| Body diameter | 2 in |
| Extended length | 26.7 in |
| Collapsed length | 17.7 in |
| Lift | 0 to 2 in |
| Finish | Silver powder coat |
Vehicle fitment
It fits the 2011 to 2013 Chevrolet Silverado 2500 HD and 3500 HD, and the 2011 to 2013 GMC Sierra 2500 HD and 3500 HD, in LT, LTZ, SLE, SLT, WT and Denali trims.
Coverage is limited to 2011 to 2013 heavy duty trucks. Match your truck’s year, model and trim to the coverage before ordering.
Installation notes
The 26.7 inch extended and 17.7 inch collapsed lengths are the figures to compare with the rear shock being removed. Because the Silverado and Sierra heavy duty trucks carry significant rear loads, check the mounting hardware before installing. The 0 to 2 inch lift range is the one listed, so measure the rear height, and confirm the shock has clearance at full compression.
Check the rear travel after installation, paying attention to clearance between the shock body and the frame at full compression. The loop mounts should be tight and square, and the boot should seat fully on the shaft.
Confirm the rear shock clears the frame, the leaf springs and the spare tire carrier, if one is fitted, at full compression.
A polyurethane boot comes with the shock, and the finish is silver powder coat.
What’s included
One PRO-M rear monotube shock with polyurethane boot under part number EXPPR2039.









