Overview
The Pro Comp Suspension EXPPR2004 is a PRO-M monotube shock kit for the 1999 to 2016 Ford F-250 and F-350 Super Duty. The shock is sold individually and includes a polyurethane boot.
An internal floating piston separates the oil from the nitrogen gas charge, which helps prevent cavitation. The 2.0 inch shock body holds more oil to help heat dissipation, and the wiper seal is designed to prevent leaks.
Key features
- Nitrogen gas charged monotube design
- Internal floating piston
- Multi-stage disc pack valving, vehicle specific
- 14 mm chrome hardened shaft
- Wiper seal design intended to prevent leaks
- Polyurethane shock boot included
- Silver powder coat finish
Monotube shock basics
A monotube shock keeps the oil and gas in one tube, separated by a floating piston. That design helps resist foaming when the shock works hard, which is why it is popular for trucks that see rough roads and towing. Shock length and mount style should match the truck’s original geometry where possible. The nitrogen charge keeps the oil pressurized, so the valving stays consistent over long runs.
Monotube shocks are sensitive to damage on the shaft, so check the chrome for pitting and the boot for tears after off-road trips. Lift changes affect the shock’s travel and the angle of the mounts, so review both when height changes. Keep the shaft clean, and replace the boot if grit has worked past it.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2004 |
| Shock series | PRO-M |
| Position | Rear |
| Extended length | 32.5 in |
| Collapsed length | 19.9 in |
| Mounts | Loop, upper and lower |
| Shaft | 14 mm chrome hardened |
| Finish | Silver powder coat |
| Boot | Polyurethane, included |
Vehicle fitment
It fits the 1999 to 2016 Ford F-250 Super Duty and F-350 Super Duty, in several trims.
Fit is limited to the Super Duty trucks named above. Verify the lift height on your truck before ordering.
Installation notes
Compare the 32.5 inch extended and 19.9 inch collapsed lengths with the shock being replaced, since a longer or shorter unit changes the rear ride height and the travel at full compression. Check the upper and lower mounts against the Super Duty’s existing hardware, and make sure the polyurethane boot clears the body at full extension.
A 6 inch lift on a Super Duty raises the rear of the truck and changes the driveline angle, so check the pinion angle after installation. The polyurethane boot should be inspected for clean seating over the shaft before the truck is loaded, and the shock should be checked for travel clearance at full compression.
What’s included
One PRO-M monotube shock with polyurethane boot under part number EXPPR2004.









