Overview
The Pro Comp Suspension PR2024 is a PRO-M rear monotube shock for the 2007 to 2021 Toyota Tundra, with 0 to 2.5 inches of lift. It has an extended length of 24.4 inches and a collapsed length of 15.5 inches, and it is sold individually.
The shock is nitrogen gas charged, with a floating piston that separates oil from gas. The multi-stage valving is tuned to each application, and the silver powder coat finish protects the body.
Key features
- Rear monotube design for 0 to 2.5 inches of lift
- Extended length 24.4 inches, collapsed length 15.5 inches
- Nitrogen gas charged with floating piston
- Multi-stage disc pack valving
- 14 mm chrome hardened shaft
- Polyurethane shock boot included
Travel and bushing checks
A rear monotube shock works through the full range of axle travel, so its clearance at full droop matters as much as its performance at full compression. Check that the shock body and the upper stem do not contact the frame or the spring perch. The stem top needs to seat fully in the upper bracket, and the loop at the lower end should move freely around the axle mount.
Tundras are often used for towing and off-road driving, which puts more load through the rear mounts. Bushings in the loop and the stem mount wear over time, and a loose mount can cause knocking over bumps. Inspect the bushings and hardware during any shock change, and replace worn parts while the shock is off the truck.
- Check clearance at full droop
- Inspect the stem top and bushing
- Tighten mount hardware after the first drives
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2024 |
| Shock series | PRO-M |
| Position | Rear |
| Extended length | 24.4 in |
| Collapsed length | 15.5 in |
| Upper mount | Stem |
| Lower mount | Loop |
| Lift | 0 to 2.5 in |
| Finish | Silver powder coat |
Vehicle fitment
It fits the 2007 to 2021 Toyota Tundra, in several trims including Base, SR, SR5, Limited, Platinum, Nightshade, TRD Pro and 1794 Edition.
Check that your Tundra’s year, model and trim match before ordering.
Installation notes
The 24.4 inch extended and 15.5 inch collapsed lengths are the figures to match against the rear shock on the Tundra. The stem top must seat correctly in the upper bracket, and the lower loop should line up with the axle mount. Check the rear travel clearance through the full range, especially if the truck has been raised within the 0 to 2.5 inch range.
Check the rear travel clearance through the full range of motion, especially if the truck has been raised within the 0 to 2.5 inch range. The stem top must seat in the upper bracket, and the lower loop should line up with the axle mount.
Confirm the rear shock clears the frame and the spring perch at full droop, and check that the mounts are seated in the factory brackets.
What’s included
One PRO-M rear monotube shock with polyurethane boot under part number EXPPR2024.






