Overview
The Pro Comp Suspension PR2127 is a PRO-M front monotube shock for 2017 to 2021 Ford F-250 and F-350 Super Duty trucks with no lift. It has an extended length of 21 inches and a collapsed length of 14.4 inches.
The shock uses a nitrogen gas charge, a floating piston and vehicle specific multi-stage valving. The shock body holds extra oil to help it run cooler on rough trails.
Key features
- Front monotube design for trucks with no lift
- Extended length 21 inches, collapsed length 14.4 inches
- Nitrogen gas charged with floating piston
- Multi-stage disc pack valving
- 14 mm chrome hardened shaft
- Polyurethane shock boot included
Stock height and front alignment
A shock for a truck at stock height works best when the front ride height matches the original setup. Measure the height before removing the old damper, since any sag or added load can change the shock’s working range. Because the truck is not lifted, the front geometry should stay close to factory, which makes a length comparison the most direct check.
Super Duty front shocks work through heavy loads, including towing and job site use. Inspect the eyelet bushings for splits, and watch for oil on the body or a clunk over bumps. Replacing the front shocks in pairs keeps both sides of the axle responding the same way, which helps steering stay predictable on mixed roads.
- Measure ride height before removing the old shock
- Inspect eyelet bushings for splits
- Replace front shocks as a pair
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2127 |
| Shock series | PRO-M |
| Position | Front |
| Extended length | 21 in |
| Collapsed length | 14.4 in |
| Lift | None |
| Finish | Silver powder coat |
Vehicle fitment
It fits the 2017 to 2021 Ford F-250 Super Duty and the 2017 to 2021 Ford F-350 Super Duty, in several trims including XL, XLT, Lariat, King Ranch, Limited and Platinum.
It is made for 2017 to 2021 Super Duty trucks. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Because this shock is for trucks with no lift, the 21 inch extended and 14.4 inch collapsed lengths should match the original front shock closely. Compare the lengths before installation, and confirm the truck is at stock height. Eyelet mounts should be checked for bushing fit, and the body should be inspected for clearance from the front spring and the frame at full compression.
Because this shock is for trucks with no lift, the front ride height should be measured before fitting, and the shock should match the original height. Confirm the eyelet mounts are seated square, and that the body has clearance from the front spring and frame through full compression.
Confirm the front shock clears the steering linkage and any brake lines at full steering lock, since the truck is not lifted.
What’s included
One PRO-M front monotube shock with polyurethane boot under part number EXPPR2127.









