Overview
The Pro Comp Suspension PR2009 is a PRO-M front monotube shock for a Ram 2500 with a 6 inch lift. It fits the 2003 to 2010 Ram 2500 and the 2011 to 2012 Ram 2500, and it is sold individually.
The shock uses a nitrogen gas charge that helps prevent cavitation, a floating piston inside the body, and vehicle specific multi-stage valving. It has a silver powder coat finish and a 14 mm chrome hardened shaft.
Key features
- Front monotube design for 6 inches of lift
- Extended length 30.3 inches, collapsed length 19.6 inches
- Nitrogen gas charged with floating piston
- Multi-stage disc pack valving
- 14 mm chrome hardened shaft
- Polyurethane shock boot included
Front geometry after a lift
A 6 inch lift raises the front axle and changes the angle of the control arms, so the steering and the front alignment both move. A shock set to the right length helps keep the suspension in its intended range, but the geometry still has to be checked once the truck is back on the ground. Caster and toe are the first settings to review after any lift.
When the front is lifted on a heavy-duty Ram, the shock carries more of the axle’s movement and more load under braking. Replacing the stem mount bushings and checking the boot at the same time helps the shock work cleanly. Look for fluid on the body, a knock over bumps, or a front end that drifts on the highway as signs the shock is worn and should be inspected.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2009 |
| Shock series | PRO-M |
| Position | Front |
| Extended length | 30.3 in |
| Collapsed length | 19.6 in |
| Upper mount | Stem |
| Lower mount | Loop |
| Lift | 6 in |
| Finish | Silver powder coat |
Vehicle fitment
It fits the 2003 to 2010 Dodge Ram 2500 and the 2011 to 2012 Ram 2500, in several trims including Laramie, SLT, ST, SXT, Sport and TRX4.
Verify the year, model and trim against your truck, especially for Ram 1500 and Ram 3500 trucks.
Installation notes
A 6 inch lift changes the front suspension geometry, so check the alignment after the shock is installed on a Ram 2500. The 30.3 inch extended and 19.6 inch collapsed lengths should be compared with the front shock being replaced. The stem top mount must fit the factory bracket, and the shock should be inspected for clearance against the axle and the frame at full droop.
A 6 inch lift on a Ram 2500 changes the geometry of the front suspension, so check the alignment and caster after installation. Confirm the stem top seats in the upper bracket, the lower loop lines up with the axle, and the body clears the spring at full droop and full compression.
Confirm the front shock is seated in the stem top bracket and that the lower loop has enough clearance from the axle to allow full droop.
What’s included
One PRO-M front monotube shock with polyurethane boot under part number EXPPR2009.









