Overview
It is a front hydraulic shock absorber for older Ford full-size trucks. It fits the 1961–1964 Ford F-100 (Base), the 1977–1979 Ford F-150 (Base, Custom, Northland, Ranger, Ranger Lariat, Ranger XLT and XLT) and the 1961–1979 Ford F-250 (Base, Custom, Northland, Ranger, Ranger Lariat, Ranger XLT and XLT).
The shock is rated for a 3 to 4 in. lift and uses the factory upper and lower mounts. Its lengths are vehicle specific. A twin tube cellular gas body, 10-stage velocity-sensitive valving and a Teflon rebound stop around a 5/8 inch chrome-hardened piston rod describe this shock. Pro Comp covers it with the double welded mounts and its limited lifetime warranty.
Key features
- Twin tube cellular gas design
- 10-stage velocity-sensitive valving
- 5/8 inch chrome-hardened piston rod
- Teflon rebound stop
- Double welded shock mounts
- Factory upper and lower mounts
- Rated for a 3 to 4 in. lift
- Pro Comp Suspension limited lifetime warranty
Front shock mounting basics
On older trucks, front shocks work with leaf or coil springs, a steering linkage and an axle that may have seen years of use. Before installing a replacement, clean the mounting studs and brackets, since rust and old paint can keep the new mounts from seating properly. Confirm the stud and eye sizes match the shock, and check the bushings for cracks or hardening.
Front shocks take a lot of side loading during turns and rough road, so the mounting hardware should be tightened to the correct torque after the first drive. Recheck the nuts after a short run, because settling in the bushings can loosen them. Keeping the old shock until the new one is confirmed fitted lets you compare lengths and angles side by side.
- Clean studs and brackets before fitting
- Inspect bushings for cracks
- Recheck mounting nuts after the first drive
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 325530 |
| UPC | 614901042290 |
| Shock series | ES3000 |
| Position | Front |
| Type | Hydraulic, twin tube cellular gas design |
| Extended, collapsed and travel lengths | Vehicle specific |
| Upper mount | Factory |
| Lower mount | Factory |
| Lift height rating | 3 to 4 in. lift |
| Adjustable | No |
| Remote reservoir | No |
| Finish | White |
| Boot included | No |
| Sold as | Each |
Vehicle fitment
It fits the 1961–1964 Ford F-100 (Base), the 1977–1979 Ford F-150 (Base, Custom, Northland, Ranger, Ranger Lariat, Ranger XLT and XLT) and the 1961–1979 Ford F-250 (Base, Custom, Northland, Ranger, Ranger Lariat, Ranger XLT and XLT).
Ford F-100 models from 1965 onward, Ford F-150 models from 1980 onward and 1976 and earlier, and F-250 models from 1980 onward are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The 3 to 4 in. lift rating covers a range, so measure your truck’s suspension height before fitting. Compare the vehicle-specific lengths with the front shock being replaced.
What’s included
One shock absorber, part 325530.
Not included: the dust boot.












