Overview
The Power Stop Z36 Truck & Tow front and rear brake upgrade kit PSTK15089DK-36 (K15089DK-36) is a complete brake pad and rotor kit for 1990-1993 Ford E-150 vans and F-150 pickups, including the 1993 F-150 Lightning. It covers both axles in one package.
The Z36 line is a bolt-on upgrade for trucks, 4x4s and SUVs that tow, haul for the jobsite or run trails. Low-dust ceramic pads reinforced with carbon fibers pair with drilled, slotted and zinc-plated rotors that help keep brake temperatures down on long descents.
Because the kit covers both axles, the pads and rotors are matched front to rear, which Power Stop presents as the simplest way to bring a 1990s Ford pickup or van up to towing duty.
Key features
- Kit for front and rear axles
- Low-dust ceramic pads reinforced with carbon fibers
- Drilled, slotted and zinc-plated rotors
- Premium stainless steel hardware included
- Bolt-on installation
- Aimed at towing, hauling and trail use
Towing with a 1990s pickup
Older pickups and vans were built before modern towing standards, so a brake upgrade is often part of a towing setup. Pads and rotors work as a pair, and the rear axle matters on a loaded truck because it carries a share of the stopping force. Check the axle and brake lines before a heavy haul.
Brake hoses and steel lines age with time, and rubber hoses can crack or swell even when the pads look fine. Inspect them during installation and at every service interval. Keep the fluid fresh, since moisture reduces the boiling point under long descents.
A trailer adds weight to every stop, so give the new brakes time to settle before loading the vehicle. Reduce speed earlier on grades and use a lower gear to limit brake heat.
- Inspect hoses and steel lines for cracks
- Check fluid condition before a tow
- Use engine braking on long descents
Specifications
| Brand | Power Stop |
|---|---|
| Part number | PSTK15089DK-36 |
| Series | Z36 Truck & Tow |
| Axles covered | Front and rear |
| Pad material | Ceramic with carbon fibers |
| Rotor design | Drilled, slotted and zinc-plated |
| Hardware | Stainless steel |
| Fit type | Direct fit |
Vehicle fitment
It fits the 1990-1993 Ford E-150 (Econoline and Club Wagon versions), the 1990-1993 Ford F-150 and the 1993 Ford F-150 Lightning.
It is made for 1990-1993 model years, so later F-150 and E-150 generations are not covered. Check your year, model and trim before ordering.
Installation notes
Bolt-on installation includes the stainless steel hardware. Because the kit replaces pads and rotors on both axles, bed in the new pads gradually before towing a heavy load.
What’s included
Brake pads and rotors for the front and rear axles, plus stainless steel installation hardware.









