Overview
The Power Stop K1861-36 is a Z36 Truck & Tow performance brake kit for the front and rear axles of the 1995–2001 Ford Explorer, the 1995–2000 Ford Explorer Sport and the 1997–2001 Mercury Mountaineer.
Power Stop explains the idea behind the kit this way: adding weight by hauling a load, towing a trailer or fitting a larger wheel and tire combination changes the conditions your stock brakes work under, and those conditions may exceed what the stock parts can handle. The kit is meant for drivers who tow and haul and for off-road enthusiasts.
The K1861-36 holds matched components built for the extra heat and brake torque that result. The drilled and slotted rotors reduce heat, while the Z36 Extreme Truck & Tow pads add the brake torque needed to bring a hauler to a stop.
Key features
- Front and rear kit supplied as a 4-wheel set
- Slotted and cross-drilled cast iron rotors
- Coated rotors
- Ceramic pads from the Z36 Extreme Truck & Tow range
- Components matched for added heat and brake torque
- Direct-fit design
Matched parts for added load
Adding a load changes the energy each brake must absorb, so the kit is built around parts that work as a set. Cross-drilled and slotted cast iron rotors help heat and gas escape from the pad surface, while a coated face slows surface rust during storage. Ceramic pads carry the friction work and are chosen here for their stable performance when the brakes run warm.
Because the front and rear parts are matched, install all four rotors and all pads together rather than mixing them with older components. Check the brake lines and fluid condition before the job, since a soft pedal under load can point to a separate fault. Bed in the new pads before towing.
- Replace all four rotors and pads together
- Check brake fluid condition before towing
- Re-torque wheel fasteners after the first drive
Specifications
| Brand | Power Stop |
|---|---|
| Part number | K1861-36 |
| Series | Z26 Street Warrior Brake Kit |
| Axle position | Front and rear |
| Rotor type | Slotted and cross-drilled |
| Rotor material | Cast iron |
| Rotor coating | Coated |
| Pad material | Ceramic |
| Fit type | Direct fit |
| Quantity | 4-wheel set |
Vehicle fitment
It fits the 1995-2001 Ford Explorer, 1995-2000 Ford Explorer Sport and 1997-2001 Mercury Mountaineer. The Explorer Sport range ends a year before the Explorer range.
Later Explorers, the Explorer Sport Trac and Mountaineer years outside 1997–2001 are not covered by this kit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit covers both axles, so it replaces the front and rear rotors and pads in one set. Power Stop designed the parts as a matched group for towing and hauling heat, so install them together rather than combining them with other pads or rotors.
What’s included
- Four slotted and cross-drilled coated cast iron rotors (front and rear)
- Ceramic Z36 Truck & Tow brake pads for each axle
Not included: Calipers and any parts not named for this kit.











