Overview
The Omix-Ada 12201.04 is a black fiberglass body mounting kit for the 1987–1995 Jeep Wrangler (YJ). It supplies the rubber, plates, brackets and hardware used to mount a fiberglass body to factory steel frames.
The kit fits YJ Wranglers in Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara and Sport trims. Some parts need welding during installation, so it is not a fully bolt-on job.
Key features
- 24 inch long roll of mounting rubber
- Two body mounting plates and four bushing back up plates
- Two fender reinforcement straps
- Clutch mount bracket, hood hinge thread plates and emergency brake pedal bracket
- All mounting bolts, washers and locknuts
Preparing for a welded install
A fiberglass body mounted to a steel frame relies on the rubber, plates and brackets to isolate movement. Before starting, clean the frame and body mounting areas so the plates sit flat and the welds have clean metal to bond to. Dry fit every bracket, then mark the positions before any welding begins.
Welding near a fiberglass body and older wiring needs care. Heat can damage resin and insulation, so protect those areas with a heat shield or remove the components from the work zone. Fasteners that do not need welding should be snug but not overtightened, since the rubber will compress as the body settles.
- Clean all contact surfaces before welding
- Dry fit plates and brackets first
- Protect fuel lines, wiring and fiberglass from heat
- Recheck body gaps after the first drive
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 12201.04 |
| UPC | 70000364465 |
| Color | Black |
| Type | Rubber |
| Fitment type | Direct fit |
| Mounting rubber | 24 inch roll |
| Body mounting plates | 2 |
| Fender reinforcement straps | 2 |
| Bushing back up plates | 4 |
Vehicle fitment
It fits the 1987–1995 Jeep Wrangler (YJ) in Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara and Sport trims.
The list covers YJ Wranglers only. Later TJ and JK Wranglers are not included. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Some parts need welding, so plan for welding equipment before starting. The bolts, washers and locknuts in the kit are for the parts that bolt on.
Wear eye protection and keep fuel lines and wiring clear of the welding area.
What’s included
The kit includes a 24 inch roll of mounting rubber, two body mounting plates, two fender reinforcement straps, a clutch mount bracket, hood hinge thread plates, an emergency brake pedal bracket, four bushing back up plates and all mounting bolts, washers and locknuts.
Not included: welding equipment, which some of the parts require.









