Overview
The Omix-Ada 12201.03 is a black fiberglass body mounting kit for the 1976–1986 Jeep CJ7. It supplies the rubber, plates, brackets and hardware for mounting a fiberglass body to factory steel frames.
The kit fits CJ7 trims Base, Golden Eagle, Golden Hawk, Laredo, Limited and Renegade. Some parts require welding during installation.
Key features
- 24 inch long roll of mounting rubber
- Two body mounting plates and four bushing back up plates
- Two fender reinforcement straps
- Clutch mount bracket, hood hinge thread plates and emergency brake pedal bracket
- Mounting bolts, washers and locknuts
Fiberglass body welding prep
Welding a bracket to a steel frame near a fiberglass body requires attention to heat and fumes. Grind the weld areas to bare metal, remove paint and scale, and protect the body panels from spatter. Plan the weld order so that pieces do not move as heat builds up.
After welding, inspect each joint for cracks and porosity before fitting the body. A weak weld can allow the body to shift on the frame over rough trails. Let the metal cool naturally rather than quenching it, and recheck that the body sits level once all brackets are in place.
- Grind weld areas to bare metal
- Protect fiberglass panels from spatter
- Inspect welds for cracks before fitting the body
- Recheck body alignment after the final weld
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 12201.03 |
| UPC | 804314148287 |
| Color | Black |
| Type | Rubber |
| Fitment type | Direct fit |
| Mounting rubber | 24 inch roll |
| Body mounting plates | 2 |
| Fender reinforcement straps | 2 |
| Bushing back up plates | 4 |
Vehicle fitment
It fits the 1976–1986 Jeep CJ7 in Base, Golden Eagle, Golden Hawk, Laredo, Limited and Renegade trims.
Confirm fit for your vehicle’s year, model and trim before ordering, especially if you are considering a CJ5 or another CJ generation.
Installation notes
Welding is needed for some of the parts, so this is not a pure bolt-on kit. Use the included bolts, washers and locknuts for the parts that do not need welding.
Disconnect the battery before welding near the body wiring.
What’s included
The kit comes with a 24 inch roll of mounting rubber, two body mounting plates, two fender reinforcement straps, a clutch mount bracket, hood hinge thread plates, an emergency brake pedal bracket, four bushing back up plates and all mounting bolts, washers and locknuts.
Not included: welding equipment, which the installation requires for some parts.









