Overview
The G2 Axle and Gear 4-XJ2-410 is a front and rear ring and pinion kit for the XJ Cherokee, with 4.10 gears on the Dana 30 reverse front and 4.11 gears on the Dana 35 rear. G2 gives no model years for this part number; the XJ code identifies the 1984–2001 Cherokee.
The kit comes with matched master installation kits for both axles. The gears are computer heat treated 8620 steel, made to O.E. specs, double shot peened and double lapped, and they come with a limited lifetime warranty. The front uses a 3.73 and up carrier and the rear uses a 3.54 and up carrier.
Key features
- 4.10 front and 4.11 rear gear sets
- Dana 30 reverse front, Dana 35 rear
- Master installation kit for each axle
- Named for the XJ Cherokee
- Limited lifetime warranty
Carrier and axle checks
Before buying gears, confirm the axles under the Jeep are the front and rear types this kit is built for. Axle tags and carrier stampings are the quickest way to check. Carrier fit matters as much as the gears, since the carrier sets the position and bearing support for the ring gear. A carrier that does not match the kit will cause noise or early failure even when the gears are correct.
When an axle is opened, inspect the old gears, bearings and differential case for wear before reusing anything. Replace the pinion seal and check the carrier bearings for play. New shims or spacers are often needed to set preload, so keep the old parts for comparison. Clean the housing thoroughly before final assembly so debris does not end up in the new gear mesh.
- Read axle tags and carrier stampings before ordering
- Check carrier bearing preload with new shims
- Inspect the differential fluid for metal particles
- Replace the pinion seal during the gear swap
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 4-XJ2-410 |
| UPC | 700007521741 |
| Product type | Front and rear ring and pinion sets with master installation kits |
| Gear ratio | 4.10 |
| Front axle gears | Dana 30 reverse 4.10 |
| Front carrier | 3.73 and up |
| Rear axle gears | Dana 35 4.11 |
| Rear carrier | 3.54 and up |
| Installation kits | Front and rear matched master installation kits |
| Material | Computer heat treated 8620 steel |
| Manufacturing | Manufactured to O.E. specs, double shot peened, double lapped |
| Warranty | Limited lifetime warranty |
Vehicle fitment
The 4-XJ2-410 is named for the XJ Cherokee, which was built from 1984 to 2001, with the same Dana 30 reverse and Dana 35 axle pairing as the 4-XJ-410. G2 gives no separate years or vehicle list for this part number.
The 4-XJ2-410 does not cover other Jeep models or an XJ with other axles. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The 4-XJ2-410 calls for pinion depth, preload and backlash to be set on both axles, which the master installation kits support. Check your carriers against the 3.73 and up front and 3.54 and up rear requirements, and plan on a professional install.
What’s included
- Front ring and pinion gear set
- Rear ring and pinion gear set
- Front matched master installation kit
- Rear matched master installation kit
Not included: carriers and anything outside the master installation kits.









