Overview
The G2 Axle and Gear 2-2011-350 is a 3.50 ratio ring and pinion for the Ford 9 inch rear axle. It installs in the rear location and suits the Ford 9 inch axle type.
G2 says its performance ring and pinion sets are built for oversized tires and high performance engines, using the latest technology and materials. A 3.50 ratio gives less torque multiplication at the wheels than a 3.70 ratio.
Key features
- 3.50 ratio rear ring and pinion
- Ford 9 inch rear axle type
- Made for oversized tires and high performance engines
- Made with the latest technology and materials
Gear ratio and tire size
Tire diameter and gear ratio work together. Larger tires act like a numerically lower gear, so a 3.50 set can feel taller than expected with oversized rubber. Choosing the right ratio means looking at the whole driveline, including transmission and transfer case gearing.
Ring and pinion work is best done as a full job. Pinion bearings, the pinion seal and the carrier bearings are often replaced together, and clean, correct tooth contact depends on setting depth and preload carefully. Use a driveline shop for setup. A notebook of backlash and preload readings makes future service easier and helps when comparing the new set with the old one.
- Check tire diameter against the new ratio
- Replace pinion bearings and seal with the set
- Inspect the carrier for wear before installing
- Verify tooth contact after the break-in period
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2011-350 |
| UPC | 631410093414 |
| Gear ratio | 3.50 |
| Axle location | Rear |
| Axle type | Ford 9 inch |
| Popular axle manufacturer | Ford |
Vehicle fitment
No vehicle model or year is tied to this 3.50 set. It is built for the Ford 9 inch at a 3.50 ratio, so confirm the housing size before ordering.
Only the Ford 9 inch is named for this 3.50 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A driveline shop should set pinion depth, backlash and bearing preload on the 3.50 Ford 9 inch gears, then complete a break-in period.
What’s included
A 3.50 ring and pinion set for the Ford 9 inch.
















