Overview
The G2 Axle and Gear 2-2031-456 is a Dana 30 short 4.56 ratio front ring and pinion for the Jeep TJ Wrangler, WJ Grand Cherokee, XJ Cherokee and ZJ Grand Cherokee.
The gears are computer heat treated 8620 steel, manufactured to O.E. specifications, double shot peened and double lapped, and they carry a 10 year warranty. The set is designed to handle oversized tires and high performance engines and needs a 3.73 and up carrier.
Key features
- Front Dana 30 short ring and pinion, 4.56 ratio
- For use in the front axle of 1997–2005 TJ Wrangler
- It also fits 1999–2005 WJ, 2000–2005 XJ and 1996.5–1998 ZJ front axles.
- Used with a 3.73 and up carrier
- Computer heat treated 8620 steel, double shot peened and double lapped
- Manufactured to O.E. specifications, with a 10 year warranty
Front axle upgrade basics
The Dana 30 front axle carries steering and a lot of off-road shock, so the ring and pinion sees hard loads when the vehicle climbs, crawls or runs larger tires. A 4.56 ratio gives extra pulling force at low speed, which is why it is a common choice for trail-focused builds.
Because the carrier is a separate part, check its size and condition before fitting new gears. Many owners replace the pinion bearings, carrier bearings, shims and the crush sleeve at the same time, since those parts wear together and are set during the same job.
Once the gears are in, the front differential should be checked for leaks, noise and tooth contact after the first drives. Bolts and cover fasteners can loosen during early use, so recheck them after the first few trail outings.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2031-456 |
| UPC | 631410093865 |
| Product type | Front ring and pinion gear set |
| Gear ratio | 4.56 |
| Axle manufacturer | Dana |
| Axle type | Dana 30 TJ (short) |
| Axle location | Front |
| Carrier | For use with 3.73 and up carrier |
| Material | Computer heat treated 8620 steel |
| Manufacturing | Manufactured to O.E. specifications, double shot peened, double lapped |
| Warranty | 10 year warranty |
Vehicle fitment
It is for use in the front axle of the 1997–2005 Jeep TJ Wrangler, the 1999–2005 WJ Grand Cherokee, the 2000–2005 XJ Cherokee and the 1996.5–1998 ZJ Grand Cherokee.
This is a front axle gear set only, and it does not cover rear axles, the YJ Wrangler or other Jeep models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Fitting the 2-2031-456 calls for correct front pinion depth, preload and backlash, and G2 requires a 3.73 and up carrier. A trained installer typically sets up the gears and supervises break-in. The carrier requirement applies to the front axle only. Fresh gear oil is needed once the front differential is closed up again.
What’s included
- One front Dana 30 short ring and pinion gear set, 4.56 ratio
Not included: an installation kit, bearings, seals and carrier, which are separate parts.














