Overview
The G2 Axle and Gear 2-2013-410 is a 4.10 ratio ring and pinion for the rear Ford 8.8 Inch axle. Inside the differential, the drive pinion turns 4.10 times for every single revolution of the ring gear, and that ratio decides how strongly engine torque reaches the tires.
The Performance Ring and Pinion line is made for oversized tires and high-performance engines, with current materials and manufacturing methods that support strength and quiet running. The set is matched to the 8.8 Inch Ford housing, so that axle type is what you verify before buying.
Key features
- 4.10 gear ratio for the Ford 8.8 Inch rear axle
- Ring gear and pinion supplied as one set
- G2 rates the set for oversized tires and high-performance engines
- Built with current materials and manufacturing methods.
- Rear axle location
Gear ratio and driving feel
The ratio is easiest to judge by how the engine turns at a given road speed. A numerically higher setting raises rpm and gives quicker response from a stop, which many drivers find useful on hills and with added weight. A lower ratio does the opposite and favors cruising. Tire diameter changes the picture too, since larger tires make the final drive effectively taller.
Gears should be chosen with the whole driveline in mind. The transmission, transfer case and tire size all change how a gear set feels, so the choice works best when it matches how the vehicle is driven most of the time. Before a swap, check the ring gear, pinion and carrier bearings for wear and replace worn parts while the axle is open, rather than reusing a tired carrier with new gears.
- Consider tire diameter alongside the gear ratio
- Check the carrier bearings and pinion seal during the swap
- Confirm the driveline angles still work after a change
- Recheck fluid level after the first trips
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2013-410 |
| UPC | 631410093452 |
| Axle type | Ford 8.8 Inches |
| Axle location | Rear |
| Gear ratio | 4.10 |
| Axle manufacturer | Ford |
Vehicle fitment
It is matched to the Ford 8.8 Inch rear axle. Verify the 8.8 Inch housing and carrier on your vehicle before you order, since the axle type is what decides fit.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Tooth pattern and backlash on a 4.10 set have to be set with precision, which is why a gear shop with setup tools is the practical choice. Expect a break-in run before heavy loads, while the new gear faces wear in.
What’s included
One 4.10 ring and pinion set for the Ford 8.8 Inch axle, part number 2-2013-410.
Not included: Carrier bearings and shims are sold separately, so buy them to match the carrier in your axle if the job calls for them.















