Overview
The G2 4-JK-456 is a 4.56 ratio front and rear ring and pinion kit for the Jeep Wrangler JK. It is made for non-Rubicon models with a Dana 30 front axle and a Dana 44 rear axle. The JK chassis code in the name covers the 2007-2018 Wrangler.
The kit supplies one matched set of ring and pinion gears for both axles, so the front and rear gears can be changed in the same job. Matched front and rear master installation kits come with the set. Carriers are sold separately, so this kit is intended for owners who are keeping their existing carriers.
Key features
- Front and rear 4.56 ratio gear sets in one kit
- Matched front and rear master installation kits included
- Computer heat treated 8620 steel gears
- Double shot peened and double lapped during manufacturing
- Built to original equipment specifications
- Covered by a limited lifetime warranty
Setup and backlash checks
Ring and pinion work is only as good as the setup behind it. Pinion depth and gear backlash need to be measured and adjusted with the proper tools, and the contact pattern on the tooth faces should be checked before the axle goes back together. A pattern that sits too high or too low on the teeth points to a setup problem that will shorten gear life.
Use fresh bearings and clean carriers when the gears are changed, since worn bearings can let the new setup move under load. Match each master installation kit to its own gear set, and keep the front and rear parts separated during assembly so nothing gets mixed up. Use the correct gear oil and break the new gears in gently over the first drives.
- Measure pinion depth and backlash
- Check the tooth contact pattern
- Replace worn carrier bearings
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 4-JK-456 |
| UPC | 700007521521 |
| Gear ratio | 4.56 |
| Front axle | Dana 30 |
| Rear axle | Dana 44 |
| Material | Computer heat treated 8620 steel |
| Carrier | Sold separately |
| Models | Non-Rubicon |
| Warranty | Limited lifetime |
Vehicle fitment
Fitment comes from the JK chassis code in the name, which covers the 2007-2018 Jeep Wrangler (JK). The kit is for non-Rubicon models with a Dana 30 front axle and a Dana 44 rear axle.
This set is for non-Rubicon models only, so Rubicon owners should check their axle setup before ordering. TJ, LJ and YJ Wranglers are outside these model years. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth and gear backlash have to be measured and adjusted after the new ring and pinion goes in, and the front and rear sets must be fitted to their own carriers. Keep each master installation kit with its matching gear set, and set the carriers with the proper tools, because an incorrect setup will wear the new gears quickly.
What’s included
Front and rear 4.56 ring and pinion sets, plus matched front and rear master installation kits.
Not included: The carriers are sold separately.




















