Overview
The G2 Axle and Gear 2-2031-373 is a Dana 30 short front 3.73 ratio ring and pinion for the Jeep TJ Wrangler, WJ Grand Cherokee, XJ Cherokee and ZJ Grand Cherokee. The 3.73 ratio matches the carrier threshold G2 gives for the whole family.
The gears are made from computer heat treated 8620 steel, double shot peened and double lapped to original equipment specifications, and they carry a 10 year warranty. They are built for oversized tires and high performance engines and are set up for a 3.73 and up carrier.
Key features
- Front Dana 30 short ring and pinion, 3.73 ratio
- For use in the front axle of 1997–2005 TJ Wrangler
- Also fits 1999–2005 WJ, 2000–2005 XJ and 1996.5–1998 ZJ
- Used with a 3.73 and up carrier
- Computer heat treated 8620 steel, double shot peened and double lapped
- Manufactured to O.E. specifications, with a 10 year warranty
Before you buy
A ring and pinion is the gear pair that carries engine power from the driveshaft to the front wheels, so its condition affects every mile the front axle drives. Before ordering, identify the carrier type, the axle housing and the current gear setup, because a gear set only works correctly with the carrier it was made for.
Gears are usually replaced as a matched set along with the pinion bearings, crush sleeve and carrier bearings. Reusing old bearings can change preload and shorten the life of new gears. A ratio change also alters engine speed at highway speed, so review tire size and transmission shift behavior while the front axle is open.
- Confirm the carrier type before ordering
- Replace the pinion crush sleeve and bearings with the set
- Inspect the axle seals and shafts while the front end is apart
- Look for pitting, chipped teeth or blue discoloration as wear signs
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2031-373 |
| UPC | 631410093841 |
| Product type | Front ring and pinion gear set |
| Gear ratio | 3.73 |
| Axle manufacturer | Dana |
| Axle type | Dana 30 TJ (short) |
| Axle location | Front |
| Carrier | For use with 3.73 and up carrier |
| Material | Computer heat treated 8620 steel |
| Manufacturing | Manufactured to O.E. specifications, double shot peened, double lapped |
| Warranty | 10 year warranty |
Vehicle fitment
The 2-2031-373 is a front axle gear set for the 1997–2005 Jeep TJ Wrangler, the 1999–2005 WJ Grand Cherokee, the 2000–2005 XJ Cherokee and the 1996.5–1998 ZJ Grand Cherokee.
This is a front axle gear set only, and it does not cover rear axles, the YJ Wrangler or other Jeep models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The 2-2031-373 front gear set needs pinion depth, preload and backlash set correctly, with a 3.73 and up carrier. Experienced installers usually handle gear setup, and new gears deserve a careful break-in. Fresh gear oil is needed once the front differential is closed up again.
What’s included
- One front Dana 30 short ring and pinion gear set, 3.73 ratio
Not included: an installation kit, bearings, seals and carrier, which are separate parts.















