Overview
The G2 Axle and Gear 2-2057-456X is a 4.56 ratio thick ring and pinion for the Toyota FJ Cruiser independent front suspension (IFS) axle. It is for use with 3.73 and down carriers, so pair it with a carrier at 3.73 or numerically lower.
G2 describes its ring and pinion sets as made for oversized tires and high performance engines. This thick 4.56 set uses computer heat treated 8620 steel with double shot peened and double lapped surfaces.
Key features
- Thick version 4.56 front ring and pinion
- It is built for the Toyota FJ IFS front axle.
- For use with 3.73 and down carriers
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Before you buy
A ring and pinion set is the pair of gears that sets the final drive ratio inside the front axle housing. On an IFS truck or SUV, the gears turn the axle shafts through the differential, so their condition affects both acceleration and how the drivetrain feels at highway speed. A thicker tooth profile like this one is intended for loads that stress the gear mesh more than stock gearing does, which is why the carrier and the rest of the front driveline need to be checked as a group.
Many owners replace the carrier bearings, pinion seal and crush sleeve at the same time as the gears. Those parts cost little compared with a second install, and fresh bearings help hold preload once the new gears are set. Before work starts, look over the existing pinion bearing for pitting or rough feel, and check the ring gear for chipped teeth. Any of those signs points to a worn assembly that should be replaced with the new set instead of reused.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2057-456X |
| UPC | 631410094695 |
| Gear ratio | 4.56 |
| Axle location | Front |
| Axle type | Toyota FJ IFS |
| Popular axle manufacturer | Toyota |
| Carrier requirement | 3.73 and down |
| Version | Thick |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
It fits the Toyota FJ IFS front axle at a 4.56 ratio. Confirm fit for your vehicle’s year, model and trim before ordering.
It is made for the Toyota FJ IFS front axle, not the non-IFS Toyota axles. Match your axle type to this set before ordering.
Installation notes
An IFS front axle needs pinion depth, backlash and bearing preload set by a driveline shop, followed by a break-in period on the 4.56 gears.
What’s included
A matched thick ring and pinion for the Toyota FJ IFS front axle.













