Overview
The G2 Axle and Gear 2-2055-488 is a 4.88 ratio front reverse ring and pinion for the Toyota 7.5 inch front axle, which G2 lists alongside the Toyota Tacoma. It is built for 3.54 and up carriers.
The ring and pinion is engineered for oversized tires and high performance engines. It uses computer heat treated 8620 steel with double shot peened and double lapped surfaces and is made to O.E. specifications.
Key features
- Front reverse ring and pinion
- 4.88 gear ratio
- For use with 3.54 and up carriers
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Front reverse basics
A front reverse ring and pinion has the gear set mounted in reverse orientation compared with a standard front axle, so the pinion and ring gear are arranged to suit the front housing layout. The setup is more involved than a rear swap, and the pinion depth and backlash set the quality of the gear contact.
Front axle gears carry load through steering and through the front hubs, so the axle shafts, hub bearings, and seals should be inspected at the same time. Keep the old set’s contact pattern as a reference, and compare it with the new set after the first short drives.
- Inspect front hub bearings and axle seals
- Compare the contact pattern with the old set
- Recheck backlash after early drives
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2055-488 |
| UPC | 631410094640 |
| Gear ratio | 4.88 |
| Axle location | Front |
| Axle type | Toyota 7.5 inch |
| Popular axle manufacturer | Toyota |
| Carrier requirement | 3.54 and up |
| Configuration | Front reverse |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
It is a 4.88 ratio front reverse set for the Toyota 7.5 inch front axle used with the Tacoma. Confirm the model year and front axle before ordering.
Only the Toyota 7.5 inch is named for this 4.88 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Front reverse gears need pinion depth, backlash and bearing preload set by a driveline shop, then a break-in period on the 4.88 ratio.
What’s included
A matched front reverse ring and pinion for the Toyota 7.5 inch front axle.












