Overview
The G2 Axle and Gear 2-2021-410 is a 4.10 ratio ring and pinion set for GM 10 bolt 8.5 inch axles. It is made for the front and rear locations on the 8.5 inch and 8.6 inch housings, and the gears are built for 2.73 and up carriers. A 4.10 ratio multiplies engine torque more at the wheels than a numerically lower gear, which matters with larger tires and heavier loads.
These gears are designed for oversized tires and high performance engines, with computer heat treated 8620 steel and double shot peened surfaces. In the 8.6 inch housing, the set works with the 35-2022 Master Kit.
Key features
- Computer heat treated 8620 steel gears
- Double shot peened surfaces
- Double lapped ring and pinion
- Manufactured to O.E. specifications
- Built for 2.73 and up carriers
- Covered by a 10 year warranty from G2
Gear ratio and driving use
Gear choice follows how the vehicle is used. Heavier tires and towing shift the balance toward lower numeric ratios for cruising, while off-road crawling and rock use favor the pulling force that a higher numeric gear adds. A 4.10 set changes engine speed at highway pace, so transmission gearing and tire diameter are worth checking together.
Break-in and setup decide how long a new set lasts. Pinion depth, backlash and bearing preload should be measured and adjusted in the carrier before installation, and the tooth contact pattern checked. Replacing the pinion bearing, carrier bearings and pinion seal when the gears change keeps the new set from running on worn parts.
- Check tire diameter against the gear choice
- Replace carrier and pinion bearings with the gears
- Recheck tooth contact after the first few drives
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2021-410 |
| UPC | 631410093544 |
| Gear ratio | 4.10 |
| Axle location | Front and rear |
| Axle type | GM 10 bolt 8.5 inch and 8.6 inch |
| Popular axle manufacturer | GM |
| Carrier requirement | 2.73 and up |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
It fits GM 10 bolt 8.5 inch and 8.6 inch axles. Confirm the housing size and carrier before ordering.
Only the GM 10 bolt 8.5 inch and 8.6 inch is named for this 4.10 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Set pinion depth, backlash and bearing preload on the 4.10 gears with a driveline shop, then follow a break-in procedure before the axle sees full load.
What’s included
The set is a matched ring and pinion for the 4.10 ratio.
Not included: the 35-2022 Master Kit, which the 8.6 inch version works with.
















