Overview
The G2 Dana 60 4.10 Ratio Ring and Pinion, part 2-2034-410, is a 4.10 gear set for the Dana 60 axle, for front or rear use.
It is made for 4.10 and down carriers. The gears are computer heat treated 8620 steel, double shot peened and double lapped, and made to O.E. specifications.
Key features
- 4.10 gear ratio
- Front or rear position listed
- For 4.10 and down carriers
- Computer heat treated 8620 steel
Fitting a Dana 60 gear set
The Dana 60 is a heavy-duty axle, and its ring and pinion are often chosen for towing, lower gearing and larger tires. A 4.10 ratio gives stronger pulling at low speed, while cruising speed drops compared with numerically lower sets. The carrier, the pinion bearings and the ring gear diameter all need to be compatible before a set is bought.
Setup is the step most often rushed. Pinion depth, backlash and bearing preload should be measured and adjusted in the carrier before installation, and the tooth pattern checked. Replacing the pinion bearings, carrier bearings and seals when the gears change prevents early wear on the new set.
- Confirm the carrier is 4.10 or lower
- Replace pinion and carrier bearings with the gears
- Check axle fluid for metal after the first drives
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2034-410 |
| UPC | 631410094138 |
| Axle type | Dana 60 |
| Axle location | Front or rear |
| Gear ratio | 4.10 |
| Carrier | 4.10 and down |
| Warranty | 10 years |
Vehicle fitment
Universal fit is listed, but no vehicle is named. The set is for Dana 60 front or rear axles at 4.10, so confirm the axle before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check that the carrier is 4.10 or lower, then set pinion depth and bearing preload before the carrier goes in the housing.
What’s included
One ring and pinion set.
















