Overview
The G2 Dana 30 JK front reverse 4.88 ratio ring and pinion, part number 2-2050-488R, is a gear set for the front Dana 30 axle in the 2007–2018 Jeep Wrangler (JK). The set has a 4.88 gear ratio and is a reverse set for the front axle.
G2 Axle and Gear builds this set for oversized tires and high-performance engines, using current materials and manufacturing technology. It is a front Dana 30 axle set with a 4.88 ratio.
Key features
- 4.88 gear ratio
- Reverse ring and pinion for the front Dana 30 axle
- Designed for oversized tires and high-performance engines
- Built with current materials and manufacturing technology
Front axle gear work
The front axle carries steering and drive loads on a Wrangler, so gear wear shows up as whine, clunking or heat under throttle. Before buying a 4.88 set, compare it with your tire diameter and decide whether the truck spends most of its time on pavement or on trail. A higher numerical ratio improves low-speed pulling power but raises engine speed on the highway.
Ring and pinion work on a Dana 30 usually goes with new pinion and carrier bearings, seals and a fresh shim pack, because those parts set the mesh the new gears depend on. Check the carrier and pinion bearing preload before reassembly, and look at the old gears for chipping and pitting.
- Check that the rotation matches your carrier before ordering
- Replace pinion and carrier bearings with the gears when possible
- Check gear oil level after the break-in period
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2050-488R |
| UPC | 631410094558 |
| Axle location | Front |
| Axle type | Dana 30 JK |
| Gear ratio | 4.88 |
| Set type | Reverse |
Vehicle fitment
It fits the front Dana 30 axle in the 2007–2018 Jeep Wrangler (JK).
It does not cover the 2018–2022 Wrangler (JL) or the Wrangler TJ and LJ. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth and backlash must be set correctly when a ring and pinion is installed, which is normally done by a professional. Gears also need a break-in period after installation.
What’s included
One ring and pinion gear set.
Not included: Pinion and carrier bearings are not included with this set.
















