Overview
The G2 Axle and Gear 4-TJRUB-456 is a 4.56 ratio front and rear ring and pinion kit for the Rubicon Jeep Wrangler TJ. The kit supplies Dana 44 gear sets for the front and the rear, which is the axle pairing for this Rubicon kit.
A ring and pinion kit like this one replaces the gears that set the axle ratio, which is the number that decides how the engine turns at a given road speed and how much torque reaches the wheels. G2 says its sets are designed to hold up to oversized tires and high performance engines.
Key features
- Front and rear 4.56 ratio ring and pinion sets
- Dana 44 gears for the front and the rear axle
- Designed to hold up to oversized tires and high performance engines
- Universal fit, so confirm the axle setup before ordering.
- Gears engineered with current technology and materials.
Before the gear swap
Ring and pinion sets handle the final drive, so their condition shapes how the whole axle feels. A worn pinion seal or a shifting carrier can cause the new gears to fail early. Inspect the carrier, bearings and seals before committing to a new set.
Sets of this type are often installed with new axle shafts, pinion seals and carrier bearings at the same time. That keeps the setup consistent and avoids reopening the housing later. Clean out old gear oil and metal particles before fitting the new sets.
A front and rear install is a good time to check the driveline angles, the U-joints and the differential cover gasket. Those small parts cost little compared with the labor of a second teardown.
- Replace pinion seals during the gear swap
- Inspect carrier bearings for play before reuse
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 4-TJRUB-456 |
| Gear ratio | 4.56 |
| Axle location | Front and rear |
| Axle manufacturer | Dana |
| Axle type | Dana 44 |
| Models | Rubicon |
Vehicle fitment
The TJ chassis code covers the 1997-2006 Jeep Wrangler. Dana 44 gear sets fit both the front and the rear axle of the Rubicon TJ.
The TJ years run 1997 to 2006, so YJ, LJ and JK Wranglers fall outside the TJ chassis. Confirm the axle setup and your vehicle’s year, model and trim before ordering.
Installation notes
Set pinion depth and backlash on each axle after the gears are installed. Confirm the carrier on each end is a Dana 44 before the swap, because the sets are matched to that axle, and keep the front and rear gear sets with their own installation parts.
What’s included
Front and rear 4.56 ring and pinion sets for Dana 44 axles.
Not included: Carriers are not part of this kit.















